Search Results

Two-Dimensional, single-shot spontaneous Raman measurements of methane concentration were performed in an optically accessible engine after direct injection with the use of modified air-assisted injector. The spatial resolution of the measurements was determined by the thickness of the laser sheet which was 0.8 mm. The error in the methane number density measurement was determined by the noise in the intensified camera output and was 16% of pure methane number density at the experimental conditions. Effective suppression of the stray light background was the main experimental difficulty. Satisfactory results were acquired only when the spark plug was substituted by a plug covered with a velvet-like, black piece of cloth. These preliminary results show that, for the specific engine configuration, fast mixing of the charge yields a very mild stratification after the end of injection.

Laser induced fluorescence from a dye contained in Unocal RF-A gasoline was excited using 355nm light and the resulting fluorescence imaged (λ>420nm). In order to minimize the changes to the intake geometry the fluorescence was collected by a fiberoptic probe with an articulatible tip. The collected light was imaged onto an intensified CCD camera synchronized with the laser, which was timed to illuminate the intake port after the completion of injection. Cold-starts from 20°C were conducted on an engine dynamometer test stand with two fuel systems: pintle-type port fuel injection, and air-forced port fuel injection. When the injection timing and initial enrichment were optimized the transient emissions from the air-forced system were significantly reduced compared with the conventional system.