Search Results

The relationship between engine oil formulations and catalyst performance was investigated by comparatively testing five engine oils. In addition to one baseline production oil with a calcium plus magnesium detergent system, the remaining four oils were specifically formulated with different additive combinations including: one worst case with no detergent and production level zinc dialkyldithiophosphate (ZDTP), one with calcium-only detergent and two best cases with zero phosphorus. Emissions performance, phosphorus loss from the engine oil, phosphorus-capture on the catalyst and engine wear were evaluated after accumulating 100,000 miles of taxi service in twenty vehicles. The intent of this comparative study was to identify relative trends.

FTP emissions from a 2.2L four cylinder vehicle are measured from six different converters. These converters have been designed to have both similar flow restriction and to have similar platinum group metals. The durability of these six converters is evaluated after dynamometer aging of both 125 and 250 hours of RATsm aging. These catalytic converters use various combinations of 400/3.5 (400 cells/in2/3.5mil wall), 400/4.5, 400/6.5, 600/3.5, 600/4.5, and 900/2.5 ceramic substrates in order to meet a restriction target and to maximize converter geometric surface area. Total catalyst volume of the converters varies from 1.9 to 0.82 liters. Catalyst frontal area varies from 68 cm2 to 88 cm2. Five of the six converters use two catalyst bricks. The front catalyst brick uses either a three-way Pd washcoat technology containing ceria or a non-ceria Pd washcoat technology. To minimize dependence on palladium the rear brick uses a Pt/Rh washcoat at a loading of 0.06 Toz and a ratio of 5/0/1.

Automotive catalysts deactivate by thermal and poison mechanisms. Thermal degradation reduces catalyst efficiency by both agglomeration of precious metals and by reduction in surface area of the washcoat. Engine oil derived poisons degrade catalyst performance by coating the outer surface of the washcoat. Numerous catalyst technologies are aged using accelerated dynamometer aging schedules that simulate the thermal and poison degradation of field aged catalysts. Pd, Pd/Rh, Pt/Pd/Rh, and Pt/Rh catalyst technologies are aged and evaluated on various rapid aging test (RATsm) schedules in an effort to ascertain what catalyst technologies may be best for low temperature and high temperature applications. The performance of these catalyst technologies are evaluated on an air/fuel sweep test and a 3.8L auto-driver FTP stand. Results show that the RATsm schedule applies a phosphorus poison distribution (due to engine oil consumption) similar to vehicle aged catalysts.

A new adsorber system for reducing cold start HC emissions has been developed that offers a passive and simplified alternative to previous HC adsorber technologies. The series flow in-line adsorber concept combines existing catalyst technology with a zeolite based HC adsorber by simply incorporating one additional adsorber catalyst substrate into conventional catalytic converters without any valving, purging lines or special substrates. The HC adsorber catalyst consist of a durable zeolite, a washcoat binder, precious group metals and rare earth promoters on standard monolithic substrates. For selected vehicle applications, a single converter containing a light off catalyst, a catalyzed HC adsorber and a standard three-way catalyst can be used in the underfloor position. Even after severe engine aging, the vehicle FTP results show that this new technology remains effective in reducing the cold start HC emissions while providing good CO and NOx conversions.

A 100,000-mile fleet test in nine gasoline-powered passenger cars was carried out. The impact of motor oil phosphorus levels on engine durability, oil degradation, and exhaust emissions has been previously described. The results of additional emissions control systems studies, and measurements of the engine oil additive elements which are present on the catalysts, are now presented. These studies include conversion efficiencies for the aged catalyst at the end of the test by a combination of light-off experiments, air/fuel sweep tests, and an auto-driver FTP. The performance of the lambda sensors is also presented. The relationships between engine oil additive levels and composition and emissions systems durability is presented.