Search Results

Emission studies and component analyses were carried out on Clear-fueled and MMT®-fueled 100,000 mile Escort vehicles from the Alliance study [SAE 2002-01-2894]. Previously reported analyses of these vehicles indicated that all differences in emission system performance could be attributed, with a 90% confidence level, to the engine cylinder head, spark plugs, oxygen sensors, and catalysts [SAE 2004-01-1084]. These parts from the Clear and MMT®-fueled vehicles were further analyzed to determine the root causes of the differences in emission system performance. The intake/exhaust valves, fuel injectors, and EGR valves from the cylinder heads were tested, individually and in groups, for differences in vehicle emission performance. Deposits from the exhaust valves of the MMT®-fueled vehicle were characterized by X-ray diffraction (XRD) and energy-dispersive X-ray spectrometry (EDX), and shown to resemble Mn3O4 with partial substitution of Zn2+ for Mn2+.

Emission studies were carried out on clear-fueled and MMT®-fueled 100,000-mile Escort vehicles from the Alliance study [SAE 2002-01-2894]. Alliance testing had revealed substantially higher emissions from the MMT-fueled vehicle, and the present study involved swapping the engine cylinder heads, spark plugs, oxygen sensors, and catalysts between the two vehicles to identify the specific components responsible for the emissions increase. Within 90% confidence limits, all of the emissions differences between the MMT- and Clear-vehicles could be accounted for by the selected components. NMHC emission increases were primarily attributed to the effects of the MMT cylinder head and spark plugs on both engine-out and tailpipe emissions. CO emission increases were largely traced to the MMT cylinder head and its effect on tailpipe emissions. NOx emission increases were linked to the MMT catalyst.

Advances in fuel control strategy, emission system architecture, and catalyst technology have led to dramatic decreases in exhaust emissions in recent years. To continue this trend, especially at high mileages, the impact of engine oil derived contaminants will need to be minimized. In this study, the deactivating effects of oil-derived contaminants on advanced catalyst technologies was assessed using an oxalic acid washing technique to remove phosphorus and other oil-derived contaminants from fleet-aged automotive three-way exhaust catalysts. Acid washing removed most of the phosphorus on the catalyst (chief poison associated with decomposition of the engine oil antiwear additive ZDDP) without significantly affecting other catalyst properties. Catalysts from eight high-mileage vehicles were analyzed, representing four vehicle families.

Vehicle evaluations and model calculations were conducted on a vacuum-insulated catalytic converter (VICC). This converter uses vacuum and a eutectic PCM (phase-change material) to prolong the temperature cool-down time and hence, may keep the converter above catalyst light-off between starts. Tailpipe emissions from a 1992 Tier 0 5.2L van were evaluated after 3hr, 12hr, and 24hr soak periods. After a 12hr soak the HC emissions were reduced by about 55% over the baseline HC emissions; after a 24hr soak the device did not exhibit any benefit in light-off compared to a conventional converter. Cool-down characteristics of this VICC indicated that the catalyst mid-bed temperature was about 180°C after 24hrs. Model calculations of the temperature warm-up were conducted on a VICC converter. Different warm-up profiles within the converter were predicted depending on the initial temperature of the device.