Search Results

Small natural gas cogeneration engines frequently operate with lean mixture and late ignition timing to comply with NOx emission standards. Late combustion phasing is the consequence, leading to significant losses in engine efficiency. When substituting a part of the excess air with exhaust gas, heat capacity increases, thus reducing NOx emissions. Combustion phasing can be advanced, resulting in a thermodynamically more favourable heat release without increasing NOx but improving engine efficiency. In this work, the effect of replacing a part of excess air with exhaust gas was investigated first in a constant volume combustion chamber. It enabled to analyse the influence of the exhaust gas under motionless initial conditions for several relative air-fuel ratios (λ = 1.3 to 1.7). Starting from the initial value of λ, the amount of CH4 was maintained constant as a part of the excess air was replaced by exhaust gas.

Lean burn operation allows small cogeneration engines to achieve both high efficiency and low NOx emissions. While further mixture dilution enables future emission standards to be met, it leads to retarded combustion phasing and losses in indicated engine efficiency. In the case of naturally aspirated engines, IMEP drops due to lower fuel fraction, increasing brake specific fuel consumption. In this work, an alternative engine configuration was investigated that improves the trade-off between engine efficiency, NOx emissions and IMEP. It combines well-established means such as Miller/Atkinson valve timing and optimised intake system for a single-cylinder cogeneration engine, operating with homogenous lean air-natural gas mixture. First, the engine configuration was analysed using a detailed 1D CFD model, implying a significant potential in reaching the project target.

A large number of small size gas-fired cogeneration engines operate with homogenous lean air-fuel mixture. It allows for engine operation at high efficiency and low NOx emissions. As a result of the rising amount of installed cogeneration units, however, a tightening of the governmental emission limits regarding NOx is expected. While engine operation with further diluted mixture reduces NOx emissions, it also decreases engine efficiency. This leads to lower mean effective pressure, in particular for naturally aspirated engines. In order to improve the trade-off between engine efficiency, NOx emissions and mean effective pressure, numerical investigations of an alternative combustion process for a series small cogeneration engine were carried out. In a first step, Miller and Atkinson cycles were implemented by advanced or retarded inlet valve closing timings, respectively.

An operation with a lean air-fuel mixture enables smaller cogeneration gas engines to operate at both high efficiency and low NOx emissions. Conventionally, the combustion process is induced through spark ignition. However, its small reactive mixture volume sets limits on increasing the air-fuel ratio, as a higher dilution reduces mixture inflammability as well as flame propagation speed. In addition, the spark plug durability is limited due to electrode wear, particularly through spark erosion, causing high maintenance costs. The ignition by means of a hot surface has great potential to extend the frequency of servicing intervals as well as to improve the trade-off between engine efficiency and NOx emissions. Compared to conventional spark ignition, ignition by means of a hot surface is achieved by accelerated combustion. The latter is produced by an increased initial reactive mixture volume.