Search Results

An air-to-fuel ratio (A/F) modulation scheme is presented in which a linear feedback signal is generated from a heated exhaust gas oxygen (EGO) sensor. In this scheme, the engine A/F is modulated with a triangular waveform, and the mean value of the EGO output is obtained using a rolling average filter. The resulting output is linearly related to the exhaust A/F, and is used to provide closed-loop lean A/F operation following a cold start to enhance catalyst light-off and minimize vehicle exhaust emissions. Some engine-dynamometer results obtained using the method are presented.

We have performed an extensive study of cycle-to-cycle variation of engine knock and its occurrence in order to have a better understanding of engine knock. Experimental studies show the randomness of knock as well as its frequency varying nature. We propose using time-frequency based signal detection method to improve knock detection since this method can track frequency variations in the measured signals. The fundamental idea behind time-frequency analysis is to be able to understand and describe how the spectral content of a signal is changing in time. Classical signal analysis has traditionally dealt with time and frequency separately. Such individual descriptions are good in situation where spectral content of signals do not change with time; however, there are often signals that have time-varying spectral content such as engine knock. It is shown that one gains more information about knock signals using time-frequency analysis method.

This paper presents a method for air/fuel ratio control using combustion pressure feedback during cold start to be used as an aid in laboratory experiments. The effects of varying air/fuel ratio during cold start are so profound that small differences in air/fuel ratio can create effects that will mask the effects of significant changes in other variables. The ability to control air/fuel ratio is an important aid in comprehensive emission studies during cold start. This work will facilitate future studies of cold start emissions.

Legislation pertaining to automobile emissions has caused an increased focus on the cold-start performance of internal combustion engines. Of particular concern is the period of time before all available sensors become active. Present engine control strategies must rely on methods other than feedback control while these sensors are not active. Without feedback control during this critical period, engine emissions performance is not optimized. These conditions cause difficulty in performing comprehensive cold-start experiments. For these reasons, we have developed several methods for feedback control during cold-start to aid in laboratory investigations of engine emissions phenomena.

Engine knock has been recognized as a major problem limiting the development of fuel efficient spark-ignition engines. Detection methods employed in current knock control systems for spark ignition engines use a measurement of engine block vibration tuned to one or more resonance frequencies to extract knock-related information from the engine structural vibration. A major problem in the detection of knock (especially at higher engine speed) in commercial engines is the isolation of the desired signal from the contributions of the components other than those associated with the phenomenon under investigation. This is generally referred to as background noise. It is known that the engine knock resonance frequencies vary due to changes in combustion chamber volume and temperature during the expansion phase. Therefore, we propose an improved knock detection method using joint time-frequency analysis of engine block vibration and pressure signals.