Search Results

More stringent emission regulations have forced an overall systems approach to meeting standards in the most effective manner. An important part of the emissions after-treatment system is the substrate. In recent years, thin wall high cell density substrates have become available. These substrates reportedly offer lower thermal mass and better heat transfer properties for faster light-off and better mass transfer properties for increased performance under stabilized conditions. This paper examines the behavior of high cell density substrate systems under a series of test conditions. A comparison of 400/6, 600/4, 600/3 and 900/2 was carried out both on a bench engine for stabilized and light-off conversion, and also under the ECE/EUDC test procedure. Bench engine results showed significant benefits for HC, CO and NOx emissions when using the higher cell density thinwall substrates.

Exhaust gas flow maldistribution can strongly affect the performance of catalytic converters. As part of an on-going programme concerned with optimising converter designs, flow maldistribution within catalyst monoliths resulting from the use of different shaped inlet cones was investigated. Computational fluid dynamics (CFD) techniques were used to predict gas velocities within the catalyst, and reaction of low levels of hydrogen sulfide in the gas was used to visualise the velocity profile on monoliths coated with a lead acetate indicator. This was done both in laboratory-scale experiments at room temperature with low flow-rates, and in a vehicle exhaust system under reduced temperature conditions. Flow patterns were produced for an underfloor catalyst system under real driving conditions with this unobtrusive chemical technique.

The emissions performance of catalytic converters under different conditions of flow distribution was investigated. Computational Fluid Dynamics methods were utilised to model the maldistribution effects of different inlet cones. The effects of maldistribution on ageing, light-off and conversion were investigated using steady state tests on an engine bench. Emission testing was also conducted on a vehicle throughout ECE and EUDC test cycles. Maldistribution was found to have a significant effect on the efficiency of the catalyst during the early stages of the ECE cycle for both fresh and aged catalysts. The effects were less significant over later stages of the ECE cycle and throughout the EUDC except NOx where maldistribution did have an effect on the conversion at higher flow rates during the later stages of the test.