Search Results

Ultrafine particles, in particular solid sub-100 nm particles pose high risks to human health due to their high lung deposition efficiency, translocation to all organs including the brain and their harmful chemical composition; due to dense traffic, the population in urban environments is exposed to high concentrations of those toxic air contaminants, despite these facts, they are still widely neglected. Therefore, the EU-Commission set up a program for clean and competitive solutions for different problem areas which are regarded to be hotspots of such particles. HORIZON AeroSolfd is an EU project, co-funded by Switzerland that will deliver affordable, adaptable, and sustainable retrofit solutions to reduce exhaust tailpipe emissions from petrol engines, brake emissions and pollution in semi-closed environments.

The increasing adoption of battery electric vehicles (BEVs), driven by the EU's target of no internal combustion engine vehicles from 2035 onwards, is driving significant changes in the automotive industry. However, the high degree of electrification and the unique low-speed acceleration behavior of BEVs therefore lead to new challenges. Measuring the drivetrain power and efficiency in a reproducible way and obtaining meaningful results is one of the challenges. To address this challenge, a novel test method is developed that offers a simple and preferably modification-free approach to drivetrain power and efficiency measurements for BEVs, allowing for efficient and reproducible testing. Different paths for determining the drivetrain power with varied measurement efforts are presented and evaluated. The test method is designed to provide reliable and accurate results for BEVs.

To replace conventional Diesel and to make the transport sector CO2 neutral, liquid bio methane or liquefied biogas (LBG) is one possible solution to replace conventional fuel. Due to the ongoing development of methane engines for trucks and the possible perspective of realizing closed CO2 cycles, a pilot project "Use of LBG (Liquefied Biogas) for Swiss heavy-duty transportation" has been launched in Switzerland. This project is intended to demonstrate the performance of LBG trucks as well as their environmental benefits. The emission behavior of the vehicles is a critical point in the evaluation of the idea of using methane as a fuel. In the present paper the conducted real drive emission measurements of two different methane gas and one Diesel powered truck, as reference, with the parallel use of a standard and FTIR-PEMS are presented. The configuration of both PEMS systems mounted on a trailer is shown, as well as the real drive scenario.

Power measuring based on chassis dynamometers allow the calculation of the vehicle motor power based only on wheel power measuring. Power and emission measuring have a long tradition in the history of combustion engine driven vehicles. Power measuring of electric vehicles and hybrid electric vehicles however is less common and the treatment of the measurement data must receive special attention due to the different drivetrains. The basic relations are summarized and applied to an electric vehicle to demonstrate the differences to the conventional combustion engine drivetrain. Based on the processed measurement data, a first proposal for a standardized test procedure for EVs is presented.

Butanol, a four-carbon alcohol, is considered in the last years as an interesting alternative fuel, both for Diesel and for gasoline application. Its advantages for engine operation are: good miscibility with gasoline and diesel fuels, higher calorific value than ethanol, lower hygroscopicity, lower corrosivity and possibility of replacing aviation fuels. Like ethanol, butanol can be produced as a biomass-based renewable fuel or from fossil sources. In the research project, DiBut (Diesel and butanol) addition of butanol to Diesel fuel was investigated from the points of view of engine combustion and of influences on exhaust aftertreatment systems and emissions. One investigated engine (E1) was with emission class “EU Stage 3A” for construction machines, another one, engine (E2) was HD Euro VI. The most important findings are: with higher butanol content, there is a lower heat value of the fuel and there is lower torque at full load.

An independent periodical technical inspection (PTI)*) of vehicles is proposed in the last time as a better prevention against increased emissions of the fleet. Several projects focused on the Diesel vehicles (HD & LD) and on the functionality of the exhaust aftertreatment systems as a key element for lowering emissions of a vehicle or machine. The present paper summarizes the results obtained on 3 modern passenger cars Euro 6b (with EGR, DOC, DPF & SCR) during load jumps, representing the heat-up or cool-down behaviour of the exhaust system. The portable devices for PTI were tested together with the stationary measuring systems of the engine laboratory. In the second part of the report, the present knowledge and proposals of supplementary test procedures (like IUC or PTI) were shortly described.

In the general efforts to replace the fossil fuels in transportation by renewable fuels the bioalcohols are an important alternative. The global share of Bioethanol used for transportation is continuously increasing. Butanol, a four-carbon alcohol, is considered in the last years as an interesting alternative fuel, both for Diesel and for Gasoline application. Its advantages for engine operation are: good miscibility with gasoline and diesel fuels, higher calorific value than Ethanol, lower hygroscopicity, lower corrosivity and possibility of replacing aviation fuels. In the present work research with different nButanol portions in gasoline (BuXX)* was performed on the 2-cylinder SI engine with variations of several parameters on engine dynamometer. At different steady state operating points were varied: spark timing (αz), air excess factor (λ) and EGR-rate. Furthermore, the conversion rates and light-off of a 3-way-catalyst were investigated.

Further efforts to reduce the air pollution from traffic are undertaken worldwide and the filtration of exhaust gas will also be increasingly applied on gasoline cars (GPF1 … gasoline particle filter). In the present paper, some results of investigations of nanoparticles from four MPI gasoline cars are represented. The measurements were performed at vehicle tailpipe and in CVS-tunnel. Moreover, two variants of GPF were investigated on a high-emitting modern vehicle, including analytics of PAH and attempts of soot loading in road application. The modern MPI vehicles can emit a considerable amount of PN, which in some cases attains the level of Diesel exhaust gas without DPF and can pass over the actual European limit value for GDI (6.0 x 1011 #/km). The GPF-technology offers in this respect further poten-tials to reduce the PN-emissions of traffic.