Search Results

Future LEV-III tailpipe (TP) emission regulations pose an enormous challenge forcing the fleet average of light-duty vehicles produced in the 2025 model year to perform at the super ultralow emission vehicle (SULEV-30) certification levels (versus less than 20% produced today). To achieve SULEV-30, regulated TP emissions of non-methane organic gas (NMOG) hydrocarbons (HCs) and oxygenates plus oxides of nitrogen (NOx) must be below a combined 30 mg/mi (18.6 mg/km) standard as measured on the federal emissions certification cycle (FTP-75). However, when flex-fuel vehicles use E85 fuel instead of gasoline, NMOG emissions at cold start are nearly doubled, before the catalytic converter is active. Passive HC traps (HCTs) are a potential solution to reduce TP NMOG emissions. The conventional HCT design was modified by changing the zeolite chemistry so as to improve HC retention coupled with more efficient combustion during the desorption phase.

In the development of HC traps (HCT) for reducing vehicle cold start hydrocarbon (HC)/nitrogen oxide (NOx) emissions, zeolite-based adsorbent materials were studied as key components for the capture and release of the main gasoline-type HC/NOx species in the vehicle exhaust gas. Typical zeolite materials capture and release certain HC and NOx species at low temperatures (<200°C), which is lower than the light-off temperature of a typical three-way catalyst (TWC) (≥250°C). Therefore, a zeolite alone is not effective in enhancing cold start HC/NOx emission control. We have found that a small amount of Pd (<0.5 wt%) dispersed in the zeolite (i.e., BEA) can significantly increase the conversion efficiency of certain HC/NOx species by increasing their release temperature. Pd was also found to modify the adsorption process from pure physisorption to chemisorption and may have played a role in the transformation of the adsorbed HCs to higher molecular weight species.

Passive in-line catalyzed hydrocarbon (HC) traps have been used by some manufacturers in the automotive industry to reduce regulated tailpipe (TP) emissions of non-methane organic gas (NMOG) during engine cold-start conditions. However, most NMOG molecules produced during gasoline combustion are only weakly adsorbed via physisorption onto the zeolites typically used in a HC trap. As a consequence, NMOG desorption occurs at low temperatures resulting in the use of very high platinum group metal (PGM) loadings in an effort to combust NMOG before it escapes from a HC trap. In the current study, a 2.0 L direct-injection (DI) Ford Focus running on gasoline fuel was evaluated with full useful life aftertreatment where the underbody converter was either a three-way catalyst (TWC) or a HC trap. A new HC trap technology developed by Ford and Umicore demonstrated reduced TP NMOG emissions of 50% over the TWC-only system without any increase in oxides of oxygen (NOx) emissions.

Passive hydrocarbon traps (“HCT”) are limited in performance when installed in an oxygen deprived location, such as an underfloor that is downstream of a CC TWC. An OEM 1.0L close-coupled converter in a 1.4L turbo hybrid PZEV calibrated vehicle was replaced with a 1.24L HC trap. The HC trap consisted of a zeolytic storage layer beneath a Pd/Rh containing three-way catalyst layer. The UF converter was upgraded with a newer TWC technology. The HC trap and UF TWC were engine aged to simulate 150,000 miles, or full useful life conditions. Criteria for accelerated engine aging of the HC trap were selected based on the vehicle application’s peak operating bed temperatures in the field. Vehicle FTP and US-06 tests were conducted on an all-wheel drive dyno which facilitated normal hybrid powertrain operation. A SULEV20 engineering target for FTP nMHC+NOx emissions was met with the full useful life aged CC HC Trap (“HCT”) system, using a PGM amount that was lower than the OEM design.

A 1.0 L underfloor converter of a 1.4 L PZEV calibrated vehicle was replaced with a 1.26 L HC trap and a 1.26 L SCR catalyst. The HC trap consisted of a zeolitic storage layer beneath a three-way catalyst layer. A newly developed catalyzed HC trap technology containing Pd/Rh was used in the current study. Increased trapping efficiency and conversion was assigned to rapid and efficient polymerization of small alkenes and aromatics coupled with more efficient combustion before release. The new trap features include the presence of strong Brønsted acidity, precious metals such as Pd and a base Mn+ redox active metal. The HC trap was followed by an SCR catalyst for NOx clean-up. The production close-coupled catalyst and replacement underfloor catalysts (HC trap and SCR) were aged on a combination of rural and highway roads for 150,000 miles. Peak bed temperatures during road aging of the HC Trap and SCR catalyst were approximately 600 °C.