Search Results

The thermal inertia of aircraft cabins and galleys is significant for commercial aircraft. The aircraft cabin is controlled by the Environment Control System (ECS) to reach, among other targets, a prescribed temperature. By allowing a temperature band of ± 2 K instead of a fixed temperature, it is possible to use this thermal dynamic of the cabin as energy storage. This storage can then be used to reduce electrical peak power, increase efficiency of the ECS, reduce thermal cooling peak power, or reduce engine offtake if it is costly or not sufficiently available. In the same way, also the aircraft galleys can be exploited. Since ECS and galleys are among the largest consumers of electrical power or bleed air, there is a large potential on improving energy efficiency or reducing system mass to reduce fuel consumption of aircraft. This paper investigates different exploitation strategies of cabin and galley dynamics using modelling and simulation.

For thermal cabin control of commercial aircraft, the cabin is usually divided into a small number of temperature zones. Each zone features its own air supply pipe. The necessary installation space for ducting increases significantly with the number of zones. This requires the number of temperature zones to be low. Factors such as seating layout, galley placement and passenger density result in deviations in heat flux throughout the cabin. These deviations cannot be compensated by the control system, if they occur within the same temperature zone. This work presents a novel temperature regulation concept based on local mixing. In this concept, two main ducts span the complete cabin length, and provide moderately warm and cold air. At each temperature zone, cabin supply air is locally mixed using butterfly valves. In this way, the number of temperature zones can be individually scaled up without any additional ducting, only requiring additional valves for each temperature zone.