Search Results

The atomization of molten aluminum when injected during high-pressure die casting is analyzed to determine its effect in enhancing the strength of the product being cast. In the previously reported first step of this study, molten aluminum was injected into open space and its atomization was observed photographically. Now in the second step of the study, a simulation is conducted to determine how the molten aluminum becomes atomized at the injection nozzle (gate) and how this atomized material flows and fills the cavity. A new simulation method is developed based on large-eddy simulation coupled with the volume-of-fluid method. The simulation system is verified by comparing its output with photographs taken in the first step of the study. Simulations are then conducted using an approximation of a real cavity to visualize how it is filled by the atomized molten aluminum.

In recent years, studies have been conducted on the relationship between the J factor, which indicates flow of molten aluminum at the time of injection, and the quality of HPDC products. The flow of molten metal at a high J factor is referred to as “Atomized Flow.” The authors and others conducted studies on the relationship between the J factor and the strength of HPDC products. An area exceeding 300MPa was found in the product produced at a high J factor corresponding to the “Atomized Flow.” The defect was less in the above-mentioned position because the gas porosity was finely dispersed. Considering that the fine dispersion of gas porosity is related to the “Atomized Flow”, pictures were taken to analyze “Atomized Flow.” The molten aluminum was ejected into an open space at a high speed and the splashed conditions were photographed. From the images taken by the pulse laser permeation, the conditions of microscopic atomized flow were observed precisely.

The advanced development and optimization of fuel atomization in port and direct injection systems for automobile engine is desired for the improvement of fuel combustion performance and thermal efficiency of the engine. Computational prediction and design of injector nozzle spray flow is an effective method for that. However, a practical simulation method of the continuous primary, secondary spray breakups and the spraying behavior have not been developed yet. In this study, we have developed the integrated computational method of the total fuel atomization process of the injector nozzle. This new computational approach is taking into account the nozzle internal flow to form the primary breakup using Volume of Fluid (VOF) method in connection with the spray flow characteristics to the engine cylinder using Discrete Droplet Model (DDM).