Search Results

Spot Welds are a category of welds used extensively in automotive structures, normally for metals. The fatigue analysis of such spot welds can be evaluated using (a) the Point 2 Point (P2P) method where a beam or bar is used to connect the 2 surfaces being joined, (b) a more modern approach where the 1D element is replaced with an “equivalent” brick element, or (c) a third approach that falls somewhere between where a “spider” and circular ring of elements, is used to represent the spot weld. In all 3 cases there is an assumption that the cross section is circular. For some specialist cases such as plastic connectors, the cross section is not circular so a new user defined weld is proposed. This paper will describe the approach that is based on the concept that a user generated tensor line can be used (equivalent to the theoretical Force/Moment to stress algorithms built into the P2P approach) along with special S-N curves create for different joint shapes.

Conventional approaches for the fatigue life evaluation of automotive parts like headlamps involves the evaluation of random stress conditions in either the time or frequency domain. If one is working in the frequency domain the fatigue life can be evaluated using one of the available methods like the Rayleigh (Narrow Band) approach or the more recent Dirlik method. Historically, the random stresses needed as input to these methods have been evaluated by the FEA solver (eg Abaqus, or Nastran) and these “in built” stress evaluations have limitations which relate to the fact that the stress conditions are complex and so the common “equivalents” for stress like von-Mises or Principal have not been available. There have also been limitations in the location and method of averaging for such stresses. In addition, the fatigue calculation approach for doing the evaluation has been constrained to the linear stress based (S-N) method.