Search Results

Automotive manufacturers are under continuous pressure to satisfy changing consumer demands and regulatory requirements in an increasingly competitive landscape. This requires Aerodynamic departments to evaluate more design ideas in less development time. Aerodynamic departments are seeking to speed up their analysis in order to provide more feedback on performance to design and styling. Vehicle designers already leverage Computational Fluid Dynamics in order to quickly assess vehicle aerodynamic performance during product development. However, in order to meet modern development challenges, reducing simulation cost and turn-around-time is necessary. To that end, a novel approach to reducing simulation time of vehicle aerodynamics without sacrificing accuracy was tested in this paper. The methodology is called Transient Boundary Seeding, and enables the usage of a reduced simulation domain without the loss of information from the omitted region.

Owing to the advantages and the rapid development of CFD methods in recent decades, CFD has become one of the most widely used tools in the field of automotive aerodynamic development. To improve the credibility of simulation, benchmarking with experiment is necessary, for which a large variety of factors should be considered, including the accuracy of digital model for the vehicle, the replication of the experimental environment in the simulation, and others. In the current aerodynamic development of passenger cars at FAW-VW, CFD models used for evaluation and optimization of aerodynamic performance replicate an open-road scenario with low blockage and full moving floor. In order to improve the benchmarking accuracy, the study of the influence of the wind tunnel geometry and ground system on simulation was carried out in this paper.

Based on the first sedan of the LYNK&CO brand from Geely, the high-performance configuration equipped with an additional aerodynamic package was developed. The aerodynamic package including front wheel deflectors, front lip, side skirts, rear spoiler, and rear diffuser, was required to be upgraded to generate enough aerodynamic downforce for better handling stability, without compromising the aerodynamic drag of the vehicle too much to keep a low fuel consumption. Starting from the baseline configuration of the aerodynamics package provided by the design studio, the components were optimized for aerodynamic drag and lift using the simulation approach with PowerFLOW in combination with a design space exploration method. As a result, the targets for the aerodynamic coefficients of the vehicle and in particular a good trade-off between lift and drag were achieved.

At SAIC-GM-Wuling (SGMW) the greenhouse wind noise performance of their vehicles has gained a lot of attention in the development process. In order to evaluate and improve the noise quality of a newly developed SUV a digital simulation based process has been employed during the early stage of the design. CFD simulation was used for obtaining the flow induced exterior noise sources. Performance metrics for the quality were based on interior noise levels which were calculated from the exterior sources using a SEA approach for the noise transmission through the glass panels and propagation to the driver’s or passenger’s head space. Detailed analysis of the CFD results allowed to identify noise sources and related flow structures. Based on this analysis, design modifications were then applied and tested in a sequential iterative process. As a result an improvement of more than 2 dB in overall sound pressure level could be achieved.

The validation of vehicle aerodynamic simulation results to wind tunnel test results and simulation accuracy improvement attract considerable attention of many automotive manufacturers. In order to improve the simulation accuracy, a simulation model of the ground effects simulation system of the aerodynamic wind tunnel of the Shanghai Automotive Wind Tunnel Center was built. The model includes the scoop, the distributed suction, the tangential blowing, the moving belt and the wheel belts. The simulated boundary layer profile and the pressure distribution agree well with test results. The baseline model and multiple design changes of the new Buick Excelle GT are simulated. The simulation results agree very well with test results.