Search Results

A 1/4 scale model vehicle profile has been tested in a wind tunnel with speeds up to 360 km/h. In order to simulate the free field flow over the vehicle, the top surface of the wind tunnel is contoured. A CFD simulation of the free field flow at various speeds is used to identify the desired top streamline. Then the boundary layer growth on the top surface is calculated and the top contour is adjusted accordingly. Since this contour changes very little with flow speeds of interest, an average contour is used for a fixed top surface of the wind tunnel. Pressure drop measurements are used to verify the flow similarity to the CFD model. Wind noise measurements using surface mounted pressure transducer arrays are used to determine the acoustic loads on the vehicle surfaces.

Road tests on a pickup truck have been conducted to determine the acoustic loads on the back panel surfaces of the vehicle. Surface mounted pressure transducers arrays are used to measure both the turbulent flow pressures and the acoustic pressures. These measurements are used to determine the spatial excitation parameters used in an SEA model of the transmission loss through the back panel surfaces. Comparisons are made between tests on different road surfaces and at different speeds to identify the relative contributions of acoustic and wind noise.