Search Results

Flow strongly affects the propagation of acoustics wave transmission within a duct and this must be addressed by the vibro-acoustic modelling of duct systems subject to non-uniform flow. Flow impacts both the effective sound propagation speed in a duct and refracts the sound towards or away from the duct walls depending on whether the acoustic waves are propagating in the direction of the flow or against the flow. Accurate modeling of the acoustic propagation within a duct is crucial for design and “tuning” of muffler systems that need to strongly attenuate narrowband acoustic sources from the engine. Muffler systems that may avoid matching acoustic resonances to engine narrowband sources when no flow is present may experience shifting of resonances to frequencies that match engine sources and cause problems when the flow during a real operating condition is present.

Statistical Energy Analysis (SEA) is widely used for modeling the vibro-acoustic response of large and complex structures. SEA makes simulations practical thanks to its intrinsic statistical approach and the lower computational cost compared to FE-based techniques. However, SEA still requires underlying models for subsystems and junctions to compute the SEA coefficients which appear in the power balance equations of the coupled system. Classically, such models are based on simplified descriptions of the structures to allow analytical or semi-analytical developments. To overcome this limitation, the authors have proposed a general approach to SEA which only requires the knowledge of impedances of the structures to compute SEA coefficients. Such impedances can always be computed from an accurate FE model of each component of a coupled system.

Predicting Vehicle Pass-by noise using simulation enables efficient development of adequate countermeasures to meet legislative targets while reducing development time and the number of physical trial-and-error prototypes and tests. It has already been shown that deterministic simulation methods such as the Boundary Element Method (BEM), which may also include directivity of sources, can support the trim package optimization process for Pass-by noise, especially for low to mid frequencies. At higher frequencies, the Ray Tracing technique, can represent an efficient alternate providing options to trade off speed versus accuracy compared to wave-based technique such as FE/BEM. This paper presents a Ray Tracing approach with high order diffraction effect. Moreover, source directivity and sound package effect are accounted for.

Optimizing noise control treatments in the early design phase is crucial to meet new strict regulations for exterior vehicle noise. Contribution analysis of the different sources to the exterior acoustic performance plays an important role in prioritizing design changes. A method to predict Pass-by noise performance of a car, based on source-path-receiver approach, combining data coming from simulation and experimental campaigns, is presented along with its validation. With this method the effect of trim and sound package on exterior noise can be predicted and optimized.