Search Results

A new electric air-cycle system of aircrafts is investigated focusing on energy recovery from the exhaust air. The working fluid of air has the higher energy level in the cabin than in the outside during the cruise because the outside air is at low pressure and low temperature. In the system, by setting a recovery turbine behind the cabin, the discharged energy can be collected, although the working fluid through the system has been only discharged from the cabin into the outside. We perform a thermodynamic cycle-analysis, where the temperature, pressure, entropy, etc. are calculated at each position of the cycle by considering the two pressure ratios of the compressors as variable parameters to show T-s diagram. In addition, we obtain an energy recovery rate of the recovery energy to the necessary power for the electric compressor. The energy recovery rate is roughly estimated 40-80% under the reasonable practical operating conditions.

In development of more electric aircraft applications, it is important to discuss aircraft energy management on various level of aircraft operation. This paper presents a computationally efficient optimization model for evaluating flight efficiency on global and interval flight ranges. The model is described as an optimal control problem with an objective functional subjected to state condition and control input constraints along a flight path range. A flight model consists of aircraft point-mass equations of motion including engine and aerodynamic models. The engine model generates the engine thrust and fuel consumption rate for operation condition and the aerodynamic model generates the drag force and lift force of an aircraft for flight conditions. These models is identified by data taken from a published literature as an example. First, approximate optimization process is performed for climb, cruise, decent and approach as each interval range path.

Current More Electric Aircraft (MEA) utilize Liquid Cooling Systems (LCS) for cooling on-board power electronics. In such LCS, coolant pipes around the structure of the aircraft are used to supply water glycol based coolant to sink heat from power electronics and other heat loads in the electronic bay. The extracted heat is then transferred to ram air through downstream heat exchangers. This paper presents a reliability examination of a proposed alternative Autonomous Air Cooling System (AACS) for a twin engine civil MEA case study. The proposed AACS utilizes cabin air as the coolant which is in turn supplied using the electric Environmental Control System (ECS) within the MEA. The AACS consists of electrical blowers allocated to each heat load which subsequently drive the outflow cabin air through the heat sinks of the power electronics for heat extraction. No additional heat exchanger is required after this stage in which the heated air is directly expelled overboard.

This paper describes the concept of an air/fuel integrated thermal management system, which employs the VCS (Vapor Cycle System) for the refrigeration unit of the ECS (Environment Control System), while exchanging the heat between the VCS refrigerant and the fuel into the engine, and presents a feasibility study to apply the concept to the future all electric aircraft systems. The heat generated in an aircraft is transferred to the ECS heat exchanger by the recirculation of air and exhausted into the ram air. While some aircraft employ the fluid heat transfer loop, the transferred heat is exhausted into the ram air. The usage of ram air for the cooling will increase the ram drag and the fuel consumption, thus, less usage of ram air is preferable. Another source for heat rejection is the fuel. The heat exchange with the fuel does not worsen the fuel consumption, thus, the fuel is a preferable source.