Search Results

An experimental campaign based on the harness and Event Data Recorder (EDR) of a production vehicle (Toyota Auris 2007, Generation 02EDR) was setup for laboratory experiments. The experiments involved triggering non-deployment events in the EDR by hitting the Airbag Control Module (ACM) with a pendulum style impactor with different pendulum weight, in frontal and rear directions and at different initial angles. The ACM was hit in three different conditions: ACM fixed, ACM free to move and ACM launched towards impactor. The wheel speed sensors were emulated with the same 7/14 mA pulses such that the vehicle was simulated to be moving with a ramping up and down speed during the impact. This was done such that the EDR data has vehicle speed in both its pre and post-crash data. The Bosch Crash Data Retrieval (CDR) tool was used to download the EDR data. Data from these experiments is shown and discussed. An in-house built sniffer was utilized to filter and store the relevant CAN bus data.

Research on turbocharging for FSAE at the University of Malta, has been ongoing for a number of years. 1D simulations were done to determine best design configuration and determine a lowered compression ratio. A decompression plate was installed on the Kawasaki 600 cc engine. Calibration of the engine was performed on the engine dynamometer. A hot-gas test stand for testing of the turbocharger was developed. The turbocharger speed was measured by a custom built hall-effect sensing setup that is compact enough to be implemented also in the FSAE vehicle. Bespoke camshafts with optimized valve timing determined through WAVE 1D simulations and designed with Valdyn® were machined. The turbocharged setup was used on the University of Malta FSAE vehicle in the FSAE Italy 2017 competition. Knock was investigated through in-cylinder pressure measurements and use of commercial knock sensor on the 600 cc engine.