Refine Your Search

Search Results

Author:
Viewing 1 to 2 of 2
Technical Paper

Analysis of Body Pressure Ratio for Evaluation of Automotive Seating Comfort

2014-04-01
2014-01-0456
Seating comfort is one of the most important indicators of the performance of automotive seats. The objective and subjective evaluation of seating comfort plays an important role in the development of seating systems. Objective methods are primarily based on evaluating the influence of vibrations on the driver's seat and assessing the seat pressure ratio. The primary goal of this study was to evaluate the comfort of two car seats (sedan and compact) by comparing a subjective technique with an objective technique like body pressure ratio for a sample of 12 subjects. The results show that the pressure ratio for IT (ischial tuberosity) and L4/L5 were significantly greater for the seat of a compact car than the seat of a sedan car. The subjective comfort was significantly greater for the seat of the sedan car and females than the seat of the compact car and males, respectively.
Technical Paper

Vibration Effect Investigation in Baby Car Seats and Automobile Seats

2014-04-01
2014-01-0462
Vibration is both a source of discomfort and a possible risk to human health. There have been numerous studies and knowledge exists regarding the vibrational behavior of vehicle seats on adult human occupants. Children are more and more becoming regular passengers in the vehicle. However, very little knowledge available regarding the vibrational behavior of child safety seats for children. Therefore, the objective of this study was to measure the vibrations in three different baby car seats and to compare these to the vibrations at the interface between the driver and the automobile seat. The test was performed on the National road at the average speed of 70 km/h and acceleration levels were recorded for about 350 Sec (5.83 min). One male driver considered as an adult occupant and a dummy having a mass of 9 kg was representing one year old baby. Four accelerometers were used to measure the vibration. All measured accelerations were relative to the vertical direction.
X