Search Results

Overheating in commercial vehicles, even though if it’s in LCV segment, is a problem of high significance. There could be various level of problems that may arise due to heat generation resulting from braking (oversized brake drums left the wheels with lesser packaging clearances for air flow and cooling) and some of them are: 1. Early tire wear /reduction in tire life, 2. Air valve heat damage /air leak issues, 3. Frequent puncture problems, 4. Failure of other mating components and other heat initiated failures. However optimum the vent hole shape in a wheel may be, the air flow in the vicinity of drum periphery and wheel rim ID wouldn’t be sufficient enough because of the lesser clearance and packaging space as mentioned earlier. The basic construction of a wheel with disc welded to rim base ID was apparently modified to integrate the disc and gutter and weld it to rim OD.

The objective of this project is to reduce the weight of a wheel without affecting its primary functions such as fitment, air flow and fatigue life, the design is made with the concept of variable thickness, meaning reducing thickness wherever the stresses are low and also addressing the failures in the field. However, requirement of a prototype makes the validation process laborious, costly and time consuming. Finite Element Method (FEM) has evolved as a resourceful tool for analyzing various components under a variety of operating conditions. It is being used not only to predict the critical points bearing the highest stress in a wheel, but also to predict its fatigue life. The present study focuses on the design of variable thickness disc and validation of the same using FEM for air flow analysis and Rig testing. The analysis was carried out on existing and proposed designs and the salient features were compared.