Search Results

In recent years, the use of ethanol fuel in internal combustion engines has gained importance due to environmental and commercial factors, since ethanol produces lower emission rates at similar performance parameters compared to gasoline fuel. The objective of this study is to evaluate and compare the effects of engine performance parameters on the vibration level of the engine block operated with gasoline and ethanol fuel. The experimental tests consisted of operating an Otto cycle engine on a bench dynamometer under full load conditions varying rotation and correlating the vertical, longitudinal and transverse vibration levels of the block engine with the engine performance parameters. The results showed that the engine vibration level was influenced by engine speed, load, type of fuel and performance parameters of the engine. The combustion process is primarily responsible for the highest level of vibration reached when using ethanol fuel.

Lubricating oils for automotive engines have been incorporating important improvements in chemical properties to increase engine performance, reduce fuel consumption and vehicular emissions indices, in addition to increasing the time interval for changing the lubricant itself. The objective of this study is to investigate the vibrational behavior of the block and crankshaft an Otto cycle internal combustion engine operated with ethanol and gasoline fuel as a function of the viscosity and total base number (TBN) of the lubricant. The study consisted of instrumenting the block and the 1st and 5th fixed bearings of the crankshaft with accelerometers to measure the engine vibration intensity and operating the engine on a bench dynamometer in a specific test cycle. Each experiment lasted 600 hours and every 50 hours a block and crankshaft engine vibration level were measured and 100ml sample of lubricating oil was collected to check viscosity and TBN chemical lubricant's properties.

Vibration problems in internal combustion engines produce premature wear on the internal components of the engine, which contributes both to reduce the lifespan of the engine itself as well as cause discomfort to the occupants of the vehicle. Thus, since it is impossible to totally eliminate vibrations from engines, it is important to understand the sources of vibration production and control them to acceptable levels. The general objective of this paper is to measure the vibration in the areas that undergo greater efforts due to the processes of combustion and mechanical forces. These areas are the fixed bearings located to the extremes of the crankshaft. The specified objective of this study is to correlate these levels of crankshaft engine vibration relative to the fuel used, ethanol and gasoline, and assess the influence of lubricant oils on the vibration levels as a function of the viscosity of the lubricant.

When analyzing vibrations in internal combustion engines, it is noticed that the greatest sources of vibrations are generated by combustion and mechanical forces. These forces occur over a wide frequency range and are transmitted to the outer surface of the engine through several paths, such as through the piston mechanism, connecting rod, crankshaft and engine block. As a result of the action of these forces, the external surfaces of the engine are subjected to vibrations of various amplitudes. Vibration problems in internal combustion engines are common due to the wide variety of parts and components that make up such engines. The crankshaft undergoes transverse, longitudinal and torsional vibrations due to the dynamics of the stresses sustained mainly during the combustion phase of the engine.

A burning process in a combustion chamber of an internal combustion engine is very important to know the maximum temperature of the gases, the speed of combustion, the ignition delay time of fuel and air mixture exact moment at which ignition will occur. The automobilist industry has invested considerable amounts of resources in numerical modeling and simulations in order to obtain relevant information about the processes in the combustion chamber and then extract the maximum engine performance control the emission of pollutants and formulate new fuels. This study aimed to general construction and instrumentation of a shock tube for measuring shock wave. As specific objective was determined reaction rate and ignition delay time of diesel, biodiesel and ethanol doped with different levels of additive enhancer cetane number. The results are compared with the ignition delay times measured for other authors.