Search Results

Electric vehicles are receiving considerable attention because they offer a more efficient and sustainable transportation alternative compared to conventional fossil-fuel powered vehicles. Since the battery pack represents the primary energy storage component in an electric vehicle powertrain, it requires accurate monitoring and control. In order to effectively estimate the battery pack critical parameters such as the battery state of charge (SOC), state of health (SOH), and remaining capacity, a high-fidelity battery model is needed as part of a robust SOC estimation strategy. As the battery degrades, model parameters significantly change, and this model needs to account for all operating conditions throughout the battery's lifespan. For effective battery management system design, it is critical that the physical model adapts to parameter changes due to aging.

Battery Management System (BMS) design is a complex task requiring sophisticated models that mimic the electrochemical behavior of the battery cell under a variety of operating conditions. Equivalent circuits are well-suited for this task because they offer a balance between fidelity and simulation speed, their parameters reflect direct experimental observations, and they are scalable. Scalability is particularly important at the real time simulation stage, where a model of the battery pack runs on a real-time simulator that is physically connected to the peripheral hardware in charge of monitoring and control. With modern battery systems comprising hundreds of cells, it is important to employ a modeling and simulation approach that is capable of handling numerous simultaneous instances of the basic unit cell while maintaining real time performance.

Lithium battery cells are commonly modeled using an equivalent circuit with large lookup tables for each circuit element, allowing flexibility for the model to closely match measured data. Pulse discharge curves and charge curves are collected experimentally to characterize the battery performance at various operating points. It can be extremely difficult to fit the simulation model to the experimental data using optimization algorithms, due to the number of values in the lookup tables. This challenge is addressed using a layered approach to break the parameter estimation problem into smaller tasks. The size of each estimation task is reduced to a small subset of data and parameter values, so that the optimizer can better focus on a specific problem. The layered approach was successful in fitting an equivalent circuit model to a lithium iron phosphate (LFP) cell data set to within a mean of 0.7mV residual error, and max of 9.2mV error at a transient.

The lithium iron phosphate (LFP) cell chemistry is finding wide acceptance for energy storage on-board hybrid electric vehicles (HEVs) and electric vehicles (EVs), due to its high intrinsic safety, fast charging, and long cycle life. However, three main challenges need to be addressed for the accurate estimation of their state of charge (SOC) at runtime: Long voltage relaxation time to reach its open circuit voltage (OCV) after a current pulse Time-, temperature- and SOC-dependent hysteresis Very flat OCV-SOC curve for most of the SOC range In view of these problems, traditional SOC estimation techniques such as coulomb counting with error correction using the SOC-OCV correlation curve are not suitable for this chemistry. This work addressed these challenges with a novel combination of the extended Kalman filter (EKF) algorithm, a two-RC-block equivalent circuit and the traditional coulomb counting method.