Search Results

We developed a novel ignition method called laser breakdown-assisted long-distance discharge ignition (LBALDI) that combines laser breakdown with a discharge to realize lean combustion. The creation of laser breakdown plasma between electrodes for discharge enables discharges over longer distances than those of conventional sparkplug as inferred from laser-triggered lightning or laser-triggered gas switches. This method should help realize volumetric ignition through the creation of a long-distance discharge. Experiments on the fundamental discharge and ignition of methane/air mixtures were conducted. The optimum incident time of the laser prior to the application of a high voltage was found to reduce the sparkover voltage and markedly reduce the voltage required by LBALDI under pressurized air conditions. In the ignition experiment, LBALDI showed the fastest heat release rate at the lean flammable limit.

Technology for the enhancement of compression ignition for a natural-gas homogeneous charge compression ignition (HCCI) engine was developed using nonthermal plasma. Specifically, nonthermal plasma was utilized to enhance the ignition of the methane/air premixture by irradiating it in an intake tube. The effect of the irradiation on compression ignition was investigated using a rapid compression and expansion machine; the ignition delay was found to shorten by the influence of irradiation. The dependence of the ignition delay time on the temperature at the end of compression was determined. Chemical analysis of the plasma-processed gas was performed using a gas detection tube as a simple method and ion-attachment ionization mass spectrometry (IAMS) as a novel method. A chemical kinetic simulation was also conducted to examine the temperature dependence of the ignition delay.

As a result of the excavation of unconventional sources of natural gas, which has rich reserves, has attracted attention as a fuel for use in natural gas engines for power generation. From the viewpoints of efficient resource utilization and environmental protection, lean burn is an attractive technique for realizing a higher thermal efficiency with lower NOx emissions. However, ignition systems have to be improved for lean-burn operations. Laser ignition, which is expected to serve as an alternative to spark plug ignition, can decrease the heat loss and has no restriction on the ignition location because of the absence of an electrode. Consequently, an extension of the lean-burn limit by laser ignition has been demonstrated. In this study, we investigated the effects of the location and number of laser ignition points on engine performance and exhaust emissions. Laser ignition was also compared with conventional spark plug ignition.

Dielectric barrier discharge (DBD) was applied to control the pressure-rise rate of homogeneous compression ignition, which is an important obstacle for homogeneous charge combustion engines. DBD can produce nonthermal plasmas and has been generated in air/fuel mixtures to reform some of the fuel molecules found in such mixtures. This generally shortens the ignition delay of compression ignition of the air/fuel premixture. Stratification of the reformed premixture in the combustion chamber was achieved by pulsed DBD irradiation during the induction process. The formation of inhomogeneous distribution of the reformed premixture is expected by the formation of discharge at the end of the intake processes. A demonstrative experiment was conducted by using a rapid compression and expansion machine. A simple plasma reactor was developed and installed at the intake tube. High-voltage, high-frequency pulses were applied to form plasmas. n-Heptane was used as fuel.

Numerical calculations were performed to investigate the mixture formation, ignition, and combustion processes in a diesel spray. The spray was formed by injecting n-heptane into a constant volume vessel under high-temperature and high-pressure conditions. The fuel droplets were described by a discrete droplet model (DDM). Numerical calculations for the flow and turbulent diffusion processes were performed on the basis of large eddy simulation (LES) to describe the processes of local non-homogeneous mixture formation and heat release. The oxidation processes in the mixture were calculated by Schreiber's five-step mechanism for n-heptane. Calculations were performed for sprays formed by single-stage injection and pilot/main two-stage injection. The flame structure in a diesel spray and its temporal change were discussed using a flame index proposed by Yamashita et al.