Search Results

Losses reduction and oil flow optimization management in construction machines and, in general, in heavy duty vehicles are two of the most challenging missions of today fluid power research. One of the most promising ideas is to implement multiple hydraulic power sources but this requires a flexible pump switch system; in fact, depending on flow request and machine mode, one or more pumps can be switched to serve each actuator. To put into practice these concepts it is necessary to in-depth design the distribution system, through which hydrostatic transmissions supply the different loads. The new component here presented realizes the pump switch management, creating a matrix framework of the hydraulic flow connections. Putting this concept it into practice the new architecture is able to connect alternatively a pump to one actuator at a time providing also for cross connections, enabling different sources flow summation.

Performance requests and machine automation, in conjunction with new regulations for commercial and heavy duty vehicles, represent a difficult challenge for machine design. Machine control systems complexity and functional safety regulation, are complex requirements to deal with in new machines design. The paper describes a steering system design, of a 6 wheeled agricultural front articulated self-propelled machine, that must comply with new regulations in terms of functional safety. The vehicle steering is driven by an electro-hydraulic system, totally controlled using electronics; the rear wheels are independently steered and controlled. This architecture requires a highly functional safety performance level. The safety analysis of the system lead to a required performance level whose compliance is a challenging task, due to the software quality required, and to the cost of a fully redundant hardware, on both electronics and hydraulics side.

Functional safety requirements and solutions are more expensive when it comes to lower cost machines with less power but same functionalities with respect to big machines. The paper will show a real Electronic Control Unit (ECU) design of a machine controller, controlling both engine working point, transmission, and other utilities like PTO, 4WD, brakes and Differential Lock; the ECU was designed in accordance to ISO 25119 regulation, to meet AgPL = C or even D for some functionalities. The unit is a fully redundant electronic control unit with two CAN networks and some special safe state oriented mechanism, that allow the Performance Level C with less software analysis requirements compared with traditional solutions. All safety critical sensors are redounded and singularly diagnosable, all command effects are directly observable and most of commands are directly diagnosable.

Alongside with the increasing vehicle complexity, the functionalities related to the safety, diagnosis and maintainability have become critical. The operators of special machines such as agricultural, mining, construction vehicles might be overwhelmed by this increased complexity and, as a result, operations for the recovery or maintenance of their vehicles become difficult. The Augmented Reality (AR) seems to be a very promising technology both if applied to traditional smart-phones or to the upcoming glasses, that has been just presented to the market by several manufacturers. This paper reviews some use cases of applications created in Institute for Agricultural and Earthmoving Machines (IMAMOTER) of the National research Council of Italy (CNR) engineers laboratories, which propose a novel approach for assisted maintenance, recovery or training.