Search Results

Autonomous vehicles perform various functions with their own control strategies. Functions like Lane Departure Warning (LDW), Lane Keeping system (LKS) and Forward Collision Warning System (FCWS) requires special test tracks for their verification and validation. These test track requirements change with region to region according to available infrastructure. This paper deals with the design and development of test tracks for different ADAS functions verification and validation of Indian specific scenarios and its simulation in IPG CarMaker. The test track conceptualization has been done through the understanding and study of different international standards and geometry of test tracks for Indian conditions have been developed. IPG CarMaker software tool is used for creation of test track, and same track is used for simulation of above ADAS functions in IPG CarMaker.

In today’s scenario, the emission norms are getting stringent day by day due to an increased level of pollution. The world is shifting towards low carbon footprint which made it necessary to adopt efficient technologies with fewer emissions. The hybridization of vehicles has resulted in improved efficiency with lower emissions which can fulfil the near future emission norms. Retrofitting of hybrid components into a conventional IC engine vehicle is so far the best way to achieve better performance both economically and technologically. This research is primarily focused on the design and development of a novel retrofit solution of P3x architecture for the light commercial vehicle. This retrofit solution is different from other hybrid solutions in terms of powertrain. It contains an innovative add-on powertrain along with the existing powertrain. This additional powertrain consists of a pair of helical gears followed by a chain and sprocket as a coupler for traction motor.

The Steering system is one of the most safety critical systems in an automobile. With time the durability, reliability and the fine-tuning of the parameters involved in this subsystem have increased along with the competitiveness of the market. In a competitive market, accelerated testing is the key to shorter development cycles. It is observed that the majority of component manufacturers have a preference on vehicle level testing to achieve their development goals. The vehicle level trials are time consuming and lack the control and repeat-ability of a laboratory environment. This paper describes the development of a steering test rig designed to simulate the disturbances experienced on road within a controlled laboratory environment. The five axis steering rig would allow simulation of individual road wheel displacement along with steering wheel angle input and lateral steering rack displacements. The rig also is designed to be adaptable to a range of vehicle categories.

A vehicle's suspension system is the basic component which decides its dynamic performance. It is designed to separate the vehicle body and its passengers or payload from vibrations arising due to road disturbances, at the same time to ensure that the tires stay in adequate contact with the road surface. Challenges in suspension design many a time's leads in a compromise between the conflicting demands of ride comfort and road holding. Vehicles having soft suspension isolate the vehicle body from the higher frequencies in suspension but reduce the ability of the dampers to control the wheel movements which leads to poor road holding. Conversely, hard suspension provides more road holding but transmits more of the suspension movement to the body; in turn provide a less comfortable ride. The development of active/ semi active suspension has addressed both these needs and provides optimum level of ride comfort and road holding which results in the safety and driving pleasure.