Search Results

In order to satisfy China IV emissions regulations, a unique design concept was proposed with injector closely coupled with Selective Catalytic Reduction (SCR) system outer body. The benefit of this design is significant in cost reduction and installation convenience. One paper was published to describe the vertical inlet layout [1]; this work is the second part describing applications of this concept to horizontal inlet configurations. For horizontal inlet pipe, two mixing pipe designs were proposed to avoid urea deposit and meet EU IV emission regulations. Computational Fluid Dynamics (CFD) technique was used to evaluate two design concepts; experiments were performed to validate both designs. CFD computations and experiments give the same direction on ranking of the two decomposition tubes. With the straight decomposition pipe design and unique perforated baffle design, no urea deposits were found; in addition, the emission level satisfied EU IV regulations.

The introduction of stringent EPA 2015 regulations for locomotive / marine engines and IMO 2016 Tier III marine engines initiates the need to develop large diesel engine aftertreatment systems to drastically reduce emissions such as SOx, PM, NOx, unburned HC and CO. In essence, the aftertreatment systems must satisfy a comprehensive set of performance criteria with respect to back pressure, emission reduction efficiency, mixing, urea deposits, packaging, durability, cost and others. For on-road and off-road vehicles, urea-based SCR has been the mainstream technology to reduce NOx emissions. For category II marine engines with single cylinder displacement volumes between 7 liters and 30 liters, IMO III (Tier IV) emission regulations dictate approximately 80% reduction of NOx emissions vs. Tier II emission regulations [1]. Urea / ammonia SCR is being considered as an enabling technology to achieve IMO III regulations without significant impacts on engine performance and fuel economy.

In order to satisfy China IV (equivalent to EU IV) emission regulations, an unconventional design concept was proposed with injector closely coupled with SCR can body. The benefit of this design is that the urea decomposition pipe was removed or drastically shortened, resulting in much smaller packaging space and lower cost of the whole system. However, the resulting short urea mixing distance generates concerns on low urea mixing efficiency and risks of urea deposits. In particular, airless urea injectors tend to generate incomplete evaporation of urea water solution, resulting in high risks of urea deposits. New aftertreatment mixing structures need to be developed to resolve these technical challenges.