Search Results

Tractors with 4WD drive perform better in slick, off road or muddy conditions (especially in Agricultural and constructional Field applications) where torque is required at all the wheels. The purpose of four wheel drive or all-wheel drive is to transmit power to all the wheels. In case of 2WD the power from engine is transferred to the rear wheels of a tractor through transmission. But in case of 4 WD tractors and construction equipment, power from engine is transferred to the front wheels through drop box and the driveline (propeller shaft). This Paper describes the need of an offset driveline where there is an offset between the Drop box output shaft center and the front axle input shaft center. This offset is the result of zero keel angle of the tractor. In order to maintain zero keel angle and transfer power to front wheels, an offset driveline with three shafts has been design &developed.

The purpose of a differential is to allow the wheels of an automobile to turn at different speeds so that it does not skid during turning. However when a vehicle runs on a slick or muddy surface (especially in Agricultural and constructional Field applications) that same feature causes the wheel with less traction to spin freely as this unit transmits power to the tire with least amount of traction. The function of a difflock is to lock the differential gears, by locking the differential, both the axles receive equal power and hence equal traction is available at both the tires. This Paper describes the positive locking of a differential by stopper, and also in detail the problems associated with its engagement and disengagement in tractors and construction equipment's. Additionally a concept for a difflock stopper which has been experimentally proven for tractors and construction equipment's is also discussed.

Manual transmissions are characterized by gear ratios that are selectable by locking selected gear pairs to the output shaft inside the transmission. Top gear is selected to get a maximum speed and is limited by the engine power, speed and the fuel economy. Lower gears are selected to get maximum speed at maximum gradient. Lower gears are also expected to give creeping speed to avoid usage of clutch and brake in city traffic. Selection of intermediate gears is such that it provides a smoother gear shift. Gear spacing is done in geometric progression. Spacing between the higher gears is usually closer than in the lower gears because drivers shift more often between the lower gears. This is opposed to the conventional idea of progressive spacing where higher gears had more space between them. An objective method is provided for selecting gear ratios for use in vehicle transmission having multiple selectable gears.