Search Results

LEV-3 regulation changes require 100% SULEV30 fleet average by 2025. While present applications meeting SULEV30 are predominately small displacement 4-cylinder engines, LEV-3 standards will require larger displacement engines to also meet SULEV30. One concept previously investigated to reduce the cold start engine-out HC emissions was to heat the fuel injected during the cold start and initial engine idle period. Improved atomization and increased vaporization of heated fuel decreased wall wetting and unburned fuel. This resulted in more fuel available to take part in combustion, thus reducing the required injected fuel mass and HC emissions. Single cylinder engine testing with experimental heated Gasoline Direct Injection (GDi) injectors was conducted at 40°C engine coolant and oil temperature conditions. The operating mode simulated cold start idle operating conditions, with split injection for improved Catalyst Light-Off (CATLO) times.

Compressed Natural Gas (CNG) is gaining popularity as a viable alternate transportation fuel in many regions of the world. Injectors capable of delivering pressurized gaseous fuels have been developed for this emerging vehicular market segment. CNG fuel injectors must be designed to be compatible and durable with a very low lubricity gaseous fuel to meet automotive OEM life expectancy standards. Traditional gasoline injectors utilize a “hard/hard” sealing configuration, in which both the valve and seat are constructed out of hard metals. When properly lubricated with liquid fuels, these valves can meet vehicular injector leak and flow durability requirements. However, metal valves operating without lubrication can experience excessive wear, which leads to unacceptable levels of gas leakage and flow shifts. The use of elastomer-to-metal sealing surfaces minimizes leakage, but may cause cold ambient operation challenges.