Search Results

This paper focuses on the investigation of the nature, process and effects of ice accretion on different feed pump strainers upstream of the aircraft feeding system. A suitable test rig was designed to circulate Jet A-1 containing water/ice contaminants at cold temperatures through the strainers. Following an extensive literature review, a number of screening tests were performed. These provided a strong base for an exhaustive study of fuel icing in the dynamic environment offered by the test rig. The effects of the rate of fuel cooling on the nature of ice were examined. As expected, it was observed that the yield of ice generated on the mesh screen increased with the water concentration in the fuel. It was also revealed that at higher cooling rates, a crust of snow formed on top of softer ice on the mesh screen.

The paper presents an extensive assessment of the hygroscopic characteristics of a number of alternative jet fuel blends. These are blended with conventional Jet A-1 to conform with current aviation standards at a 50:50 ratio by volume, except for DSHC (Direct Sugar to Hydrocarbon), which is blended at 10% DSHC and 90% Jet A-1. Given the lack of information available on the water solubility of alternative jet fuels, an effective analysis of experimental data about this characteristic in six different alternatives was performed. These included four ASTM approved alternatives (two Fischer-Tropsch (FT) synthetics from coal and natural gas, one HEFA (Hydroprocessed Esters and Fatty Acids) derived from camelina and DSHC. An extra two alternatives currently under consideration for ASTM approval were also tested; ReadiJet and an ATJ (Alcohol to Jet).

Water is always present in jet fuel, usually in a mixture of forms. At very low temperatures this phenomenon can lead to the formation of ice crystals within the aircraft fuel system, which can then stay in suspension within the entire volume of fuel. Pumps within the fuel system transfer fuel around the system. Pumps such as boost pumps that are typically used in fuel systems are protected by a weave type filter mesh at the inlet. Ice accretion on the surface of this mesh has operational implications as it can cause non optimal fuel flow. In this investigation, two fundamental tools are being used: 1) a high fidelity MATLAB model of a mesh strainer, pick-up line and pump, and 2) a test rig of the modelled system. The model is being used to investigate fuel system performance when exposed to fuel containing water/ice contaminants at cold temperatures.