Search Results

Press hardenable ultra high strength steel (UHSS) is commonly used for automotive components to meet crash requirements with minimal mass addition to the vehicle. Press hardenable steel (PHS) is capable of forming complex geometries with deep sections since the forming takes place at elevated temperatures up to 900 degrees Celsius (in the Austenitic phase). This forming process is known as hot-stamping. The most commonly used PHS grade is often referred to as PHS1500. After hot-stamping, it is typically required to have a yield strength greater than 950 MPa and a tensile strength greater than 1300 MPa. Most automotive design and material engineers are familiar with PHS, the hot-stamping process, and their capabilities. What is less known is the capability of 3rd Generation advanced high strength steels (AHSS) which are cold stamped, also capable of forming complex geometry, and are now in the process of, or have recently completed, qualification at most automotive manufacturers.

NHTSA has been investigating a new test mode in which a research moving deformable barrier (RMDB) impacts a stationary vehicle at 90.1 kph, a 15 degree angle, and a 35% vehicle overlap. The test utilizes the THOR NT with modification kit (THOR) dummy positioned in both the driver and passenger seats. This paper compares the behavior of the THOR and Hybrid III dummies during this oblique research test mode. A series of four full vehicle oblique impact crash tests were performed. Two tests were equipped with THOR dummies and two tests were equipped with Hybrid III dummies. All dummies represent 50th percentile males and were positioned in the vehicle according to the FMVSS208 procedure. The Hybrid III dummies were instrumented with the Nine Accelerometer Package (NAP) to calculate brain injury criteria (BrIC) as well as THOR-Lx lower legs. Injury responses were recorded for each dummy during the event. High speed cameras were used to capture vehicle and dummy kinematics.