Search Results

Legislations worldwide have started imposing stringent emission standards for particulate matter (PM) emitted by diesel engines. The main reason for these actions is the adverse effects on human health caused by particle emissions. Conventional ceramic Diesel Particulate Filters (DPF) have proven exceptionally effective in reducing particulate emissions with efficiencies of 90% or more. However, these filters require regular active regenerations as well as periodical ash removal in order to avoid a blockage of the exhaust line. These procedures are both costly and complex and as a result alternative aftertreatment solutions have been developed. One of these solutions is the Particle Oxidation Catalyst, POC-X. The main aim of the POC-X is not to equal the high efficiencies of the DPF, but to achieve the best possible particle reduction without creating the risk of blocking or the need for complex filter regeneration procedures.

Different particulate mass (PM) portable emission measurement systems (PEMS) were evaluated in the lab with three heavy-duty diesel engines which cover a wide range of particle emission levels. For the two engines without Diesel Particulate Filters (DPF) the proportional partial flow dilution systems SPC-472, OBS-TRPM, and micro-PSS measured 15% lower PM than the full dilution tunnel (CVS). The micro soot sensor (MSS), which measures soot in real time, measured 35% lower. For the DPF-equipped engine, where the emissions were in the order of 2 mg/kWh, the systems had differences from the CVS higher than 50%. For on-board testing a real-time sensor is necessary to convert the gravimetric (filter)-based PM to second-by-second mass emissions. The detection limit of the sensor, the particle property it measures (e.g., number, surface area or mass, volatiles or non-volatiles) and its calibration affect the estimated real-time mass emissions.