Search Results

Air traffic has been steadily increasing for the last years. Moreover, fuel availability at a reasonable cost seems more and more uncertain. Climate change implies that greenhouse gases emissions should be reduced. In this context, the search for new alternative fuels for aircraft seems to be a promising solution. Nevertheless, aeronautic represents a very specific transportation mode, due to its usage (short range, middle range, long range with the same fuel, worldwide distribution of the fuel…) and its compulsory security constraints. In the first part of the European project ALFA-BIRD (Alternative Fuels and Biofuels for Aircraft development - FP7), a selection of the best candidates to become the fuels for the future of aircraft has been done. The selection process was very complex, due to multiple criteria (physical properties, economical issued, environmental issues…).

In a context of a fossil reserve depletion and reduction of greenhouse gases (GHG) emissions, the search for new energy for transport is fundamental. Among those new energies, alternative fuels and especially synthetic fuel from Fischer-Tropsch process (so-called XtL, "X-to-Liquid" fuels) seem to have an interesting potential in terms of availability and GHG emission reduction, according to the feedstock used. Due to the special properties of such products, especially high cetane number, several strategies of incorporation can be envisaged: as a blend in specific basestocks in order to obtain a conventional fuel or a premium fuel or as a pure component. In order to assess these strategies; a standard diesel fuel (B0), a blend with 40%vol of Fischer-Tropsch and a neat Fischer-Tropsch have been tested on a modern downsized high pressure direct injection single-cylinder diesel engine. The used Fischer-Tropsch fuel is a commercial GtL - Gas to Liquid, with a cetane number higher than 80.

Facing more and more stringent regulations, new solutions are developed to decrease pollutant emissions. One of them have shown promising and relevant results. It consists of the use of ethanol as a blending component for diesel fuel Nevertheless, the addition of ethanol to Diesel fuel affects some key properties such as the flash point. Consequently, Diesel blends containing ethanol become highly flammable at a temperature around ambient temperature. This study proposes to improve the formulation of ethanol based diesel fuel in order to avoid flash point drawbacks. First, a focus on physical and chemical properties is done for ethanol based diesel fuels with and without flash point improvement. Second, blends are tested on a passenger car diesel engine, under a wide operating range conditions from low load low speed up to maximum power. The main advantage of the ethanol based fuels generate low smoke level, that allows using higher EGR rate, thus leading to an important NOx decrease.

This work studies the potential of ethanol-Biodiesel-Diesel fuel blends in both conventional Diesel and HCCI combustion modes. First, ethanol based fuels were tested on a modern commercial multi-cylinder DI diesel engine. The aim of this phase was to assess how such fuels affect Diesel engine performances and emissions. These results indicate that low levels of PM and NOx emissions, with a contained fuel consumption penalty and with an acceptable noise level, are achievable when the Diesel-ethanol blends are used in combination with an optimized combustion control. Moreover, experiments with ethanol based blends were performed using a single cylinder engine, running under both early injection HCCI and Diesel combustion modes. Compared to a conventional fuel, these blends allow increasing the HCCI operating range and also lead to higher maximum power output in conventional Diesel combustion.

Due to the increasing use of Fatty Acid Methyl Esters (FAME) in diesel fuel blends and the sensitivity of the latest Diesel engine technology (higher pressures and temperatures), a reliable method for predicting the thermal stability of biodiesel fuels is required. A laboratory bench test, called MicroCoking test, which usually qualifies engine oils, has been modified in order to be used for biodiesel blended fuels. Experimental conditions, and especially temperature range, were optimized in order to lead to a sensitive and discriminating method to qualify pure biodiesel fuels and Diesel blends containing FAME.