Search Results

Strategies for weight reduction have driven the noise treatment advanced developments with a great success considering the already mastered weight decreases observed in the last years in the automotive industry. This is typically the case for all soft trims parts. In the early 2010's a typical european B-segment car soft trims weights indeed 30 to 40% less than in the early 2000's years. The main driver behind such a gap has been to combine insulation and absorption properties on a single part while increasing the number of layers. This product-process evolution was conducted using a significant improvement in the simulation capacities. In that sense, several studies presenting very good correlation results between Transmission Loss measurements and finite elements simulations on dashboard or floor insulators were presented. One may consider that those kinds of parts have already achieved a considerable improvement in performance.

Due to increasing attention paid to the optimization of leakages and passthroughs in general, measurements on cut out modules in large coupled reverberant rooms are often carried out in the middle and high frequency range, in order to optimize the insulation performance of trims installed in their actual environment (Transmission Loss). Using optimal controlled mounting conditions, we have been able to extend the frequency range to the low frequencies in order to validate trim FEM models of a headliner cut out module with structureborne and airborne excitations.

The weight reduction challenge has taken a new shape in the past two years due to high pressure on CO2 emissions in the automotive industry. The new question is: what level of acoustic performance can you get with an insulator weighting less than 2500 g/m2? The existing solutions at this weight being mainly dissipative (absorption) concepts give a satisfactory performance only if the pass-throughs are poor and present critical leakages. Respecting the less than 2500 g/m2 weight target, we have developed a wide range of new or optimized concepts switching from extremely absorbing to highly insulating noise treatments playing with multi-layers insulators (typically three to four layers), in combination or not with tunable absorbers on the other side of the metal sheet (in the engine compartment for example).

The challenge of a NVH development is to define a link between the target of the OEMs expressed in terms of acoustic performance, weight and cost and the design of the optimized acoustic package reaching this target. The “Vehicle Acoustic Synthesis Method” (VASM) has been developed in order to create this link. The VASM method, which is an energy based hybrid simulation technique, calculates the Sound Pressure Level at ear location from the combination of sound power measurements and acoustic frequency response functions (FRF) panel/ear, either measured or simulated with Ray-Tracing Methods.