Search Results

Four-way, integrated, diesel emission control systems that combine selective catalytic reduction for NOx control with a continuously regenerating trap to remove diesel particulate matter were evaluated under real-world, on-road conditions. Tests were conducted using a semi-tractor with an emissions year 2000, 6-cylinder, 12 L, Volvo engine rated at 287 kW at 1800 rpm and 1964 N-m. The emission control system was certified for retrofit application on-highway trucks, model years 1994 through 2002, with 4-stroke, 186-373 kW (250-500 hp) heavy-duty diesel engines without exhaust gas recirculation. The evaluations were unique because the mobile laboratory platform enabled evaluation under real-world exhaust plume dilution conditions as opposed to laboratory dilution conditions. Real-time plume measurements for NOx, particle number concentration and size distribution were made and emission control performance was evaluated on-road.

This paper reports on the first phase of a project that explores the trends and dependencies of the input power to the major mechanically-driven accessories including hydraulic pumps, air compressor, air conditioning (AC) compressor, and alternator on a modern parallel hybrid city bus. In this first phase, the impact of accessory electrification is estimated by considering the near-elimination of accessory overdrive and parasitic loading. In addition to reducing accessory fuel consumption accessory electrification can also serve as a bridge to the eventual use of a diesel or fuel cell auxiliary power unit to generate electricity for accessories on transit buses. Data collection and processing methods of this study are described, the shortcomings of mechanically-driven accessories are discussed, and an estimation of savings for accessory electrification is performed.

The objective of this work is to improve the understanding of variables like dilution and sampling conditions that contribute to particle-based emission measurements by assessing and comparing the nucleation tendency of diesel aerosols when diluted with a porous wall dilutor or an air ejector in a laboratory setting. An air-ejector dilutor and typical dilution conditions were used to establish the baseline sensitivity to dilution conditions for the given engine operating condition. A porous tube dilutor was designed and special attention was given to integrating the dilutor with the exhaust pipe and residence time chamber. Results from this system were compared with the ejector dilutor. Exhaust aerosols were generated by a Deere 4045 diesel engine running at low speed (1400 rpm) and low load (50 Nm, ~10% of rated). Primary dilution parameters that were varied included dilution air temperature (25 and 47°C) and dilution ratio (5, 14, and 55).