Search Results

A new predictive zero-dimensional low-throughput combustion model has been applied to both PCCI (Premixed Charge Compression Ignition) and conventional diesel engines to simulate HRR (Heat Release Rate) and in-cylinder pressure traces on the basis of the injection rate. The model enables one to estimate the injection rate profile by means of the injection parameters that are available from the engine ECU (Electronic Control Unit), i.e., SOI (Start Of main Injection), ET (Energizing Time), DT (Dwell Time) and injected fuel quantities, taking the injector NOD (Nozzle Opening Delay) and NCD (Nozzle Closure Delay) into account. An accumulated fuel mass approach has been applied to estimate Qch (released chemical energy), from which the main combustion parameters that are of interest for combustion control in IC engines, such as, SOC (Start Of Combustion), MFB50 (50% of Mass Fraction Burned) have been derived.

Faults in the intake and exhaust path of turbocharged common-rail diesel engines lead to an increase of emissions and to performance losses. Fault detection strategies based on plausibility checks, threshold based trend or limit checking of sensor data are not able to detect and isolate all faults appearing in the intake and exhaust path without increasing of the number of sensors. The need to minimize mass and reduce cost, including the number of sensors, while maintaining robust performance leads to higher application of models for intake and exhaust path components. Therefore a concept of model based fault detection with parity equations is considered. It contains the following parts: modeling, residual generation with parity equations using parallel nonlinear models, fault to symptom transformation with masking of residuals dependent on the operating point and limit violation checking of the residuals.

Future automotive engines have to comply with upcoming emission legislations (EURO 6, CARB 2) raising the requirements on onboard diagnostic systems (OBD). Faulty conditions of the engine leading to higher emissions must be detected with rising accuracy. Additionally, car manufacturers have a strong interest in improving the reliability of fault diagnosis in their workshops in the sense of being able to find the smallest changeable part. The legislation requirements can be reached using the present methodology, as has been shown in first series applications. But advanced methods of model-based fault detection and isolation can help to accomplish with future requirements as well as to extend the present OBD systems, especially with the ability of detecting small faults and the ability of a root cause isolation.