Search Results

In this paper, the performance of a radial turbine working under pulsatile flow conditions is computed with two different modeling approaches, time resolved 1-dimensional (1-D) and 3-dimensional (3-D) CFD. The 1-D modeling approach is based on measured turbine maps which are used to compute the mass flow rate and work output from the turbine for a given expansion ratio and temperature at the inlet. The map is measured under non-pulsatile flow conditions, and in the 1-D method the turbine is treated as being a quasi-stationary flow device. In the 3-D CFD approach, a Large Eddy Simulation (LES) turbulence approach is used. The objective of LES is to explicitly compute the large scales of the turbulence while modeling the effects of the unresolved scales. Three different cases are considered, where the simplest case only consist of the turbine and the most complex case consist of an exhaust manifold and the turbine.

Surge is a phenomenon that limits the operational range of the compressor at low mass flow rates. The objective of this research is to study effective operational range for a ported shroud compressor. The size of the compressor is typical for a turbocharger used on diesel engines. To be able to extend the operational range, the surge characteristics have to be assessed. This is done by performing measurement of the flow at the inlet to the compressor wheel and pressure fluctuations at the inlet and outlet of the compressor housing. Detailed numerical computations of the flow in the entire compressor section under similar operating conditions have also been carried out. The experimental work includes Particle Imaging Velocimetry (PIV) measurements of the instantaneous and mean velocity field at the inlet. At surge, low frequency pulsations are detected that seem to result from back flow already observed in stall.