Search Results

Technologies of 4WD chassis dynamometers (CHDY hereinafter) have advanced dramatically over the past several years, enabling 4WD vehicles to be tested without modifying their drive-train into 2WD. These advances have opened the use of 4WD-CHDY in all fuel economy and emission evaluation tests. In this paper, factors that influence the accuracy of fuel economy tests on 4WD CHDY are discussed. Fuel economy tests were conducted on 4WD CHDY and we found that most of the vehicle mechanical loss is the tire loss and that stabilizing the tire loss of the test vehicle is essential for the test reproducibility.

In order to develop the engines that emit only small amount of Particulate Matter (PM), there are various demands for measurement techniques for PM, such as real-time measurement, low-mass measurement, and analysis in short time. This paper reviews two kinds of instruments that have been newly introduced for PM measurement. One is the real-time PM analyzer applying two Flame Ionization Detectors (FID). This method utilizes an area accumulation technique for spike-shaped signals that are observed when soot particles are fed into a FID detector. And Soluble Organic Fraction (SOF) can be calculated continuously from difference of signals of two detectors. Another is the low-mass PM analyzer based on process of vaporization, oxidization and deoxidization. The performances of these two measurement techniques are described in this paper, using model samples and actual particulate.

For the purposes of environmental protection, regulations of particulate matter are becoming more stringent year by year. Accordingly, engine systems have been improved and particulate emissions are much lower compared to those of previous engine systems. The automotive industry generally uses a gravimetric method to quantify particulate emissions. It is becoming increasingly difficult to quantify particulate emissions using a conventional gravimetric balance because the amount of particulates continues to decline. In order to overcome this problem, a new method has been developed that uses gas analyzers to measure potentially as much as several micrograms of particulates. Furthermore, with this method, it is possible to simultaneously analyze volatile organic fraction (VOF), soot, and sulfates. The particles collected by a quartz filter are placed in a furnace at a specific temperature, and VOF and sulfates are vaporized in an inert atmosphere.

The environmental effects of particulate matter (PM) emissions from vehicles are an increasing concern to those concerned with air quality. A variety of technologies have been developed to measure exhaust particulates. The automotive industry generally uses the gravimetric method to quantify particulate emissions. This method uses a combination of a dilution tunnel and filter to collect PM from the diluted sample gas. The collected PM is later weighed on a microbalance. Because this technique is a batch measurement, it is not possible to determine at what point of an emissions test drive cycle the soot, soluble organic fraction (SOF) and total PM are emitted. A more accurate characterization of PM emissions will require real-time PM measurement under transient test conditions.

The next generation of diesel engines will require substantial reductions in particulate matter (PM) emissions. In addition to strict regulations, one of the major problems in the development is the lack of sophisticated real-time PM analyzers. The current PM measurement technology consists of a dilution tunnel and filter weighing technique that was developed before the 1980s.(1) Such technology has reached its limit for today's diesel exhaust monitoring requirements in terms of response time and sensitivity. A flame ionization detector (FID), commonly used for measuring hydrocarbons, is proposed as a new analyzer for PM. In the past, spike signals observed from the FID when measuring diesel exhaust have been considered noise and a lot effort has been spent to reduce such interference from the slower FID signal. However, given a fast response time FID, these spike signals could be used to represent PM concentration in the sample.