Search Results

Methanol, a fuel obtainable through the capture and conversion of Carbon Dioxide (CO2), has garnered attention as a suitable alternative fuel for gasoline. Methanol-gasoline blends, characterized by their high-octane rating, commendable performance, and reduced carbon emissions, present themselves as promising alternative fuels for internal combustion engines. In the present study, a comprehensive comparative analysis was conducted to assess the performance and emissions characteristics of unmodified vehicles utilizing methanol blends at lower concentrations, ranging up to 30%, in gasoline. The research focused on two distinct classes of vehicles commonly found on the roads of India: those compliant with BS-IV (Euro IV) and BS-VI (Euro VI) emission standards. Experimental evaluations were carried out on a chassis dynamometer, with the vehicles subjected to the Worldwide Harmonized Motorcycle Test Cycle (WMTC) and Wide open throttle (WOT) driving tests.

Conventional automotive ignition systems are known for their ability to ignite fuel-air mixtures with a spark, which is an example of thermal plasma. In recent times it has been demonstrated that compared to thermal plasma, non-thermal plasma is an effective means of enhancing combustion. To establish this point, an experimental setup was built, and experiments were carried out in a Constant Volume Combustion Chamber (CVCC) with a conventional J type spark plug. Under atmospheric conditions, the combustion tests were carried out with methane-air mixtures. A nano-second, high voltage repetitive pulse discharge generator was used as a non-thermal plasma ignition source. To generate thermal plasma, an induction-based automobile ignition system was used. Flame propagation inside the CVCC was captured using a high-speed camera by employing shadowgraph imaging.

A large quantity of fuel is injected into the cold manifold of the engine to enable a quick start. A substantial part of this fuel gets deposited on the manifold walls leading to the formation of a fuel pool. Improper fuel vaporization during the engine cold start leads to the formation of a large amount of HC emissions. In the present investigation, a small flexible polyamide strip heater was placed at a specific location where the fuel impingement happens to enhance fuel vaporization in a 4-stroke motorcycle engine. The heater was turned on 20 seconds before the engine started. A temperature controller was used to maintain the heater at 323 K. The emission data for 180 seconds from the engine start was measured. Initial tests were carried out without the heater to establish the baseline emissions. Later, tests were carried out with the heater switched on and compared. The results showed a 32 % reduction in cumulative HC emissions with the use of the heater.

A numerical and experimental study on performance and emission characteristics of four-stroke, four-cylinder Multi Point Injection (MPI) engine operating on iso-butanol/gasoline blends was carried out. The study aims at extending the widely used Wiebe function to combustion modeling of alternate fuels. Quasi one-dimensional simulation and experiments were carried out for different blends of iso-butanol and gasoline (0% (pure gasoline), 10% (IB10), 20% (IB20), 30% (IB30), by volume of iso-butanol) at wide open throttle (WOT) condition for five engine speeds in the range of 2000 to 4000 rpm. The computational and experimental results complement each other validating the proposed extension. BSFC of the blends initially drops for IB10 and later rises with increase in concentration of iso-butanol. Compared to gasoline, the blends lead to considerable decrease in the amount of unburned hydrocarbons (HC) and no change of carbon monoxide (CO).