Search Results

The deployment dynamics of a tape-spring style, folding MAV wing in flight are complicated and an investigation is made using wind tunnel testing. High speed photography is used to characterize the deployment motion of the wing while a force balance records six- axis aerodynamic loading of the model. An in-flight deployment of a folding wing would be advantageous after an autonomous tube launch, however the dynamics are potentially problematic due to buckling. Steady state aerodynamics of prototype tube-launch MAVs are characterized for both rigid body and compliant, rolling wings. Aerodynamic phenomena associated with the significant relative body size are identified. Wing deployments are demonstrated at four different angles-of-attack at single velocity, while an extreme case deployment is shown at a high velocity. Two-piece cylindrical shells are used to retain the wing prior to deployment and are released by hot-wire cutting of retaining lines.

In this paper two different tools have been applied to the problem of designing a small UAV. With these tools a parametric study of wing configuration and sizing was performed. The focus of this study was to optimize range and endurance of the UAV during a particular flight mission. The two numerical analysis tools applied to the UAV wing design were developed for widely different analysis problems. The first tool, the aircraft DATCOM was developed for the preliminary design analysis of manned aircraft and will be used to perform parametric modeling and geometry optimization. The Projectile Rocket Ordinance Design and Analysis System (PRODAS®) software was developed for ballistic projectiles and will be used for 6 DOF fixed plane trajectory simulation of the developed UAV concepts. While the scale of the UAV selected does not match well with the DATCOM software, the mission requirements and analysis format of the software is advantageous.

The vibration response from undamaged and damaged polymer matrix composite beams at elevated temperatures is analyzed using the Hilbert-Huang Transform (HHT) technique. The HHT shows potential in identifying the nonlinear damaged response of the beams. Using empirical mode decomposition to separate superposed modes of signals, several intrinsic mode functions can be determined which can reveal more information about complex nonlinear signals than traditional data analysis techniques such as the Fourier Transform. The composite beams are fabricated from an out-of-autoclave uniaxial carbon/epoxy prepreg (CYCOM™-5320-1/T650). Delamination damage in the composite layups is introduced by insertion of mold release wax films during fabrication. A shaker-table fixture was used for the vibration testing of all beams in a vertical cantilever configuration. High temperature piezoelectric accelerometers were used to obtain the vibration data for a frequency range of 1-61 Hz.

Polymer matrix composites are increasingly adopted in aerospace and automotive industries due to their many attributes, such as their high strength to weight ratio, tailorability, and high fatigue and durability performance. However, these materials also have complex damage and failure mechanisms, such as delaminations, which can severely degrade their strength and fatigue performance. To effectively and safely use composite materials in primary structures, it is essential to assess composite damage response for development of accurate predictive models. Therefore, this study focuses on determining the response of damaged and undamaged carbon epoxy beams subjected to vibration loadings at elevated temperatures. The Hilbert-Huang Transform (HHT) technique is used to analyze the beams’ modal response. The HHT shows potential in identifying the nonlinear damaged response of the beams.