Search Results

As the exhaustion of petroleum resources and air pollution problems are getting more serious day by day, demands for low emission levels and higher thermal efficiency of vehicle engines have been increased. In light of this, the diesel engine has many advantages such as high thermal efficiency, a cheaper price of fuel, and what is more it has a low CO2 exhaustion level well known as the factor of ‘Global Warming’, therefore the use of diesel engines is getting increased. However in the case of diesel engine, NOx increases in the local high temperature region, and particulate matter increases in fuel rich regions. That is why, getting down the peak temperature to reduce NOx emission and making better air-fuel mixing to minimize particulate matter formation are required and Homogeneous Charge Compression Ignition (HCCI) is a technique which can make those conditions.

Emissions remain a critical issue affecting engine design and operation, while energy conservation is becoming increasingly important. One approach to favorably address these issues is to achieve homogeneous charge combustion and stratified charge combustion at lower peak temperatures with a variable compression ratio, a variable intake temperature and a trapped rate of the EGR using NVO (negative valve overlap). This experiment was attempted to investigate the origins of these lower temperature auto-ignition phenomena with SCCI and CAI using gasoline fuel. In case of SCCI, the combustion and emission characteristics of gasoline-fueled stratified-charge compression ignition (SCCI) engine according to intake temperature and compression ratio was examined. We investigated the effects of relative air/fuel ratio, residual EGR rate and injection timing on the CAI combustion area.

Owing to the presence of oxygen atoms in biodiesel, the use of this fuel in compression ignition (CI) engines has the advantage of reducing engine-out harmful emissions. In this context, biodiesel fuel can also be used to extend the low temperature combustion (LTC) regime because it inherently suppresses soot formation within the combustion chamber. Therefore, in this study, LTC characteristics of biodiesel were investigated in a single cylinder CI engine; the engine performance and emission characteristics with biodiesel and conventional petro-diesel fuels were evaluated and compared. A modulated kinetics (MK)-like approach was employed to realize LTC operation. The engine test results showed that LTC operation was achieved by retardation of the fuel injection timing. The results also showed that using biodiesel reduced smoke, THC, and CO emissions but increased NOx emissions.

Automotive manufacturers and engineers have paid attention to promoting engine performance with low emissions satisfying many emission regulations. With such goals in mind, we have investigated new cooling strategies such as high coolant temperature control, fast warm-up and post cooling using an automotive cooling system controlled by electronic actuators. The cooling system in a 2.7 liter HSDI engine was modified for the purpose of this study, and an engine experiment was carried out on a New European Drive Cycle (NEDC). The conventional water pump was decoupled from the engine and electronically controlled by a BLDC motor. Valves were installed at the coolant pathways between the engine and cooling components. Overall, this modification led to a reduction in both fuel consumption and exhaust gas emissions (e.g. THC, CO). The reduction was particularly considerable at the low speed and low load-drive conditions by controlling high temperature of the coolant.

In present days, most of researches concerned with vehicle engines have been performed to reduce vehicle emissions and to improve engine efficiency. For the requirements, LPG (Liquefied Petroleum Gas) engine which has lots of advantages such as low emission level, cheaper fuel cost and enough infrastructures has had lots of interest as an alternative fuel engine. What is more, it has a low emission level of CO2 well-known as the factor of ‘Global Warming’, thus the use of LPG engines has been increased. Especially since MPI(Multi Point Injection) type LPLi(Liquid Phase LPG injection) system was used for the fuel supply system, disadvantages of LPG engine such as low engine performance, decreased charging efficiency and cold starting difficulty have been improved and prejudices against LPG engines have been changed a lot. In light of this, the motion to use LPLi engines instead of diesel engines has been increasing.