Search Results

This paper provides an analysis of how communication performance between vehicles using Dedicated Short-range Communication (DSRC) devices varies by antenna mounting, vehicle relative positions and orientations, and between receiving devices. DSRC is a wireless technology developed especially for vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2I) communications. A frequency band near 5.9 GHz has been set aside in the US and other countries for exploring safety and other uses for road vehicles. DSRC devices installed onboard vehicles broadcast their location using global navigation space systems (GNSS), speed, heading, and other information. This can be used to study communication performance in many scenarios including: car-following situations, rear-end crash avoidance, oncoming traffic situations, left turn advisory, head-on crash avoidance and do-not-pass warnings.

Excessive wind noise is one of the most complained problems by owners of new vehicles as evidenced by JD Power Initial Quality Study (IQS) in recent years. After the vehicle speed surpasses 100 km/h, wind noise is gradually becoming the dominant noise source. In an effort to reduce aeroacoustic noise level, Beamforming (BF) is a very effective noise source identification technique used during vehicle wind noise development phases. In this work, based on the planar BF methodology, a large semi-circle microphone array is designed in accordance with the desired resolution and dynamic range pertaining to actual noise source distribution on a typical passenger vehicle. Acoustic array calibration and mapping deformation correction are accomplished by multi-point source method, and the Doppler Effect due to wind is corrected by the location calibration method.

Three thermo-wires with amplifying circuits have been developed to measure the time-resolved concentration of the exhaust gas recirculated into the intake manifold by a rotary valve-based exhaust gas recirculation (EGR) system of a diesel engine. Good agreement was found between the EGR rates measured by the temperature based system and a conventional CO2 tracing system. The developed EGR measuring system was used to investigate the EGR transient response in a turbo-charged and after-cooled diesel engine with a real-time measure and control system. The EGR response under EGR valve step change and engine transient operating conditions are discussed. At first, the engine was running under a certain steady condition with zero recirculated exhaust gas, then the rotary valve opened to maximum within 0.1s to demonstrate the EGR step change behavior. EGR rate and air intake stabilized in 0.5s.

The incomplete combustion and misfire of diesel engine during starting result in unwanted white smoke. The histories of combustion and emission in different phases under different start conditions were studied in this paper. The optimization of the fuel injection control strategy under start conditions was performed. When the diesel engine is started under low temperature, the control strategy adapted to start the engine with a certain constant fuel mass injected per cycle, there may be misfire cycles in the initial period or in the transitional process, which is mainly caused by the mismatch between the fuel mass injected per cycle and the instantaneous engine speed. Therefore, an optimized control strategy was put forward, namely, the engine starts with high fuel mass injection in the first several cycles and then decreases step by step during the transitional period until it operates at idle condition. This strategy was validated to decrease significantly the misfire cycles.

A novel non-destroy repeatable-use impact theory based total cylinder sampling system has been established. This system is mainly composed of a knocking body and a sampling valve. The knocking body impacts the sampling valve with certain velocity resulting in huge force to open the sampling valve and most of the in-cylinder gas has been dumped to one sampling bag for after-treatment. The feasibility and sampling response characteristics of this impact theory based total cylinder sampling system were investigated by engine bench testing. Within 0 to 35°CA ATDC (Crank Angle After Top Dead Center) sample timing 50 percent to 80 percent of in-cylinder mass would be sampled, which was a little less compared with the traditional system. The half decay period of pressure drop was 10 to 20 degrees crank angle within 0 to 60°CA ATDC sample timing, which was about 2-3 times of the traditional system.