Search Results

In electric or hybrid electric transmissions, the transmission fluids can be in contact with the parts of the electric motors, for example, electrical windings in the stators in order to efficiently cool the electric motors and to insulate the electrical parts to prevent a short circuit of the electric motors. The transmission fluids must therefore have low electrical conductivities [1,2,3,4,5,6,7,8,9]. Transmission fluids contain dispersants, which can be reaction products of hydrocarbyl substituted carboxylic acids or anhydrides and amines. These dispersants can be further post-treated with boron and phosphorus compounds to improve friction and anti-wear properties. Certain dispersants, which have nitrogen content up to 10,000 ppm by weight, and boron plus phosphorus to nitrogen ((B+P)/N) weight ratios of from 0.1 to about 0.8 : 1.0, were found to be effective to provide low electrical conductivities less than 1,700 pS/m [10].

This report focuses on an extended investigation of the durability of Dual Clutch Transmission (DCT) fluids. The performance requirements of DCT fluids differ from those of traditional step automatic transmission fluids. For that reason, key performance lab tests are discussed in this paper. Friction durability is measured with a modified version of the JASO M348 SAE#2 friction plate test. In addition, results from a vehicle chassis dynamometer test are discussed. This test involves running a 2008 Volkswagen GTI for 60,000 dynamometer miles (42,000 cycles) of severe acceleration and high speed conditions. Finally, a new DCT fluid, which performs well in these tests, offers friction stability and superior wear protection of transmission hardware, when compared to the commercial reference fluid.

This laboratory presents a new step-automatic transmission fluid with enhanced friction durability and robustness for the Asian marketplace. This mineral-oil-based fluid also meets JASO M315-1A performance requirements on torque capacity, anti-oxidation, anti-wear, extreme pressure (EP), anti-aeration/foam control, copper corrosion and anti-rust performance. The fluid offers a JASO M349 low velocity friction apparatus (LVFA) durability lifetime of over 1100 hours. Moreover, this fluid maintains stable torque capacity during its entire LVFA durability lifetime, across the temperature range of 40 to 120 °C. Similarly, friction level changes with sliding speed are smaller than experienced by other commercial factory-fill ATFs. These critical performance features are due to a new fluid friction system approach, which may enable new types of transmission hardware or calibration.