Search Results

The First Law of Thermodynamics has been applied to the analysis of the dynamometer performance of a 2.0 litre,115 PS, common rail, turbocharged, automotive diesel engine operating under steady state conditions. Validation of the method is presented with correlation between the input fuel power and summed loss terms shown to be better than 3%. The study was conducted over a matrix of engine speed-load sites and maps of the underlying trends and magnitudes are presented. Detailed analysis of the relative heat balance contributions at a range of loads at fixed engine, water pump, and oil pump speeds is also presented. The proportions of heat rejected to the different primary paths (i.e. brake, coolant, oil, charge cooler, exhaust, and external) were found to vary with engine speed and load. Also, friction power was found to vary principally as a function of engine speed with some small dependency on engine load.

In this paper, data are presented showing how lubricant properties affect the heat flux, oil flow rates and temperatures within a turbocharged diesel passenger car engine. The oils tested cover a range of viscosities and base oil types. Mono-grades were used to remove the effect of shear thinning. The effect of viscosity modification was also examined. Lowest viscosity lubricants resulted in the lowest sump temperatures. More fuel was required to produce the same brake output from the engine with thicker oils. Engine oil heat rejection increased with viscosity, not just in absolute terms, but also as a fraction of the total heat loss. Viscosity does affect oil temperature through increased total heat from friction, and also through its effect on heat transfer. In addition, oil viscosity is itself dependent on operating temperature. Heat transfer theory suggests a relation between mass flow rate and heat transfer.