Search Results

An innovative hydrogen DI system was conceived, realized and tested that requires only 12 bar rail pressure, typical value of PFI systems, and does not need special injectors. The purpose is to combine the well-known benefits of DI with the ones of PFI. The injection is accomplished in two steps: at first hydrogen, metered by an electroinjector (a conventional one for CNG application), enters a small intermediate chamber; then it is injected into the cylinder by means of a mechanically actuated valve that allows very high flow rate (compared with the one of electroinjectors). In-cylinder injection starts at intake valve closing (an earlier injection start could lead to backfire) and stops early enough to allow proper charge homogeneity and, in any case, before cylinder pressure rise constrains hydrogen admission. The prototype engine was realized modifying a production single-cylinder 650 cm₃ engine with three intake valves.

The purpose of this work is to perform an analysis on the modifications necessary to convert a four-stroke engine into a non-conventional two-stroke engine. The first aim of this work is to reach the theoretical advantages of the two stroke engine (high torque values at lower rpm and working regularity) and, at the same time, to avoid the usual problems of the two stroke cycle (short-circuit of fresh air-fuel mixture and consequently pollutant emissions and high specific fuel consumption). The target is to develop a small engine with innovative solutions that allows to obtain high performance coupled with good mechanical and thermodynamic efficiency. The starting base engine is a 125cc four-stroke two-valves scooter engine equipped with a volumetric compressor. The idea is to convert it from four to two stroke cycle, using head valves and adding scavenge ports in the cylinder.