Search Results

This paper presents a combined experimental and numerical study of a modified Cooperative Fuel Research (CFR) engine that allows both the Research and Motor octane numbers (RON and MON) of any arbitrary Liquefied Petroleum Gas (LPG) mixture to be determined. The design of the modified engine incorporates modern hardware that enables accurate metering of different LPG mixtures, together with measurement of the in-cylinder pressure, the air-fuel ratio and the engine-out emissions. The modified CFR engine is first used to measure the octane numbers of different LPG mixtures. The measured octane numbers are shown to be similar to the limited data acquired using the now withdrawn Motor (LP) test method (ASTM D2623). The volumetric efficiency, engine-out emissions and combustion efficiency for twelve alternative LPG mixtures are then compared with equivalent data acquired with the standard CFR engine operating on a liquid fuel. Finally, the modified CFR engine is modelled using GT-Power.

An optically accessible single-cylinder high-speed direct-injection (HSDI) Diesel engine equipped with a Bosch common rail injection system was used to study the spray and combustion processes for European low sulfur diesel, bio-diesel, and their blends at different blending ratio. Influences of injection timing and fuel type on liquid fuel evolution and combustion characteristics were investigated under similar loads. The in-cylinder pressure was measured and the heat release rate was calculated. High-speed Mie-scattering technique was employed to visualize the liquid distribution and evolution. High-speed combustion video was also captured for all the studied cases using the same frame rate. NOx emissions were measured in the exhaust pipe. The experimental results indicated that for all of the conditions the heat release rate was dominated by a premixed combustion pattern and the heat release rate peak became smaller with injection timing retardation for all test fuels.