Search Results

Natural gas is regarded as one of the most potential alternative fuels of engines because of its fruitful storage, good obtainable resources, and high octane value, etc. Compared with port fuel injection (PFI), Gasoline direct injection (GDI) has many advantages on volumetric efficiency improvement, lean-burning, emissions control, etc. A set of measuring and data acquisition system on CNG direct injection spark-ignited engines and the CNG multi-direct injection system are developed in this paper. Based on different injection modes of CNG single DI and compound DI (main injection and auxiliary-Injection), the investigations on combustion process of CNG DI engines has been conducted by the factors of in-cylinder mixture formation, air/fuel ratio, and injection timing, etc. Meanwhile, the three-dimension simulation on mixture formation and combustion principle of low-pressure CNG compound direct injection engines has also been researched.

The cold starting and cold-state running cycle (i.e. engine warming up) of gasoline engines are the key points of exhaust emissions formation of modern engines, and also one of the very important targets for the increasingly stringent emissions regulations. The combustion stability in gasoline engine cold starting and warming up will impact the formation of its exhaust emissions. This paper introduces the improvement in cold starting and warming up combustion process for the motorcycle gasoline engine by high-energy, dual-spark plug based rapid burning system. Test results showed that the high-energy, dual-spark plug based rapid burning system was very helpful to rapid ignition under the engine cold starting condition. Meanwhile, because of increasing the burning velocity of the engine mixture, this solution can realize the larger ignition retard and stable combustion process under the engine warming-up condition.

Exhaust Gas Recirculation (EGR) is an extensively applied approach for the engine emission control, which is the most effective for reducing NOX emissions. However, as increasing EGR rate, the burning velocity of LPG mixture will be slow that it impacts the complete combustion and combustion stability. The effects of EGR on the rapid lean-burning and NOX emissions of the LPG engine with EFI is introduced in this paper. Test data showed that the dual-spark plug ignition-based rapid burning system could increase the combustion rate of LPG mixture, and improve the rapid burning process of the LPG engine with EGR. Meanwhile, the excess air rate Φa limits of LPG lean-burning will be largely extended within the whole effective range of EGR rate. At the equivalent running conditions of LPG engine, largely extended EGR rate could restrain the formation of NOX emissions by the high combustion temperature.

An electronic controlled rapid burning system with a high energy, dual-spark plug ignition system in a high speed LPG engine with a sole LPG-fueled port fuel injection (PFI) system for the steady state lean operation is discussed in this paper. A Multi-channel SI engine Combustion Process Analysis System was developed in this research. The synchronizing and asynchronous ignition timing can be realized by ECU and the control strategies according to the engine operation conditions. Test results showed that the lean mixture flame propagation was improved by the enhanced ignition energy intensity in this system. To cooperate with the combustion chamber and the spark location, the flame propagation distance was shortened for rapid burning.

This paper presents an engine management system to control a 4-stroke two-cylinder motorcycle engine. At the heart of the system is a microcontroller based reference design engine control unit. This works together with a crank wheel sensor, throttle position sensor, oxygen sensor, manifold pressure sensor, injectors, ignition coils and fuel pump. This system has the capability to detect engine position, sense throttle position, calculate mass airflow from air temperature, control fuel injection timing and amount, control spark timing and dwell. It has idle control with stepper motor and closed-loop feedback of oxygen levels in the exhaust. To achieve fast closed-loop control, the controller turns on an oxygen heater. Serial communication via KWP2000 is used for reprogramming of the controller and reading diagnostic codes. The main goal of this system is to meet emission requirements and provide OBD capability. Some results on an actual motorcycle will be presented.