Search Results

Assessment of the physical evidence on a seat belt restraint system provides one source of data for determining an occupant’s seat belt use or non-use during a motor vehicle crash. The evidence typically associated with loading from a restrained occupant has been extensively researched and documented in the literature. However, evidence of loading to the restraint system can also be generated by other means, including the interaction of an unrestrained occupant with a stowed restraint system. The present study evaluates physical evidence on multiple stowed restraint systems generated via interaction with unrestrained occupants during a full-scale dolly rollover crash test of a large multiple passenger van. Unbelted anthropomorphic test devices (ATDs) were positioned in the driver and right front passenger seats and in all designated seating positions in the third, fourth, and fifth rows.

In rear-end collisions, the seatback provides primary occupant restraint during initial rearward motion of the occupant relative to the vehicle interior as the vehicle is accelerated forward by collision forces. When properly used, seat belts contribute to limiting occupant excursion and loading by working in concert with the seatback, as well as managing forward excursion on rebound after rear-end impacts. A lack of data evaluating the role of seat belt restraint component technology in limiting occupant motion and loading during high-severity rear-end impacts has been identified. This knowledge gap is particularly apparent for occupants who are not seated normally, in position, at the time of impact. Previous static pretensioner deployment tests suggest that different combinations of latch plate design and pretensioner deployment strategies might have different effects on occupant restraint.

The role of seatback strength on occupant motion during rear-end collisions has been a focus of scientific investigation for decades. Despite being an integral component of the occupant restraint system, the role of seat belt restraints and the potential effect of various seat belt restraint system components, like pretensioners and latch plate design, on occupant motion and injury potential during rear-end collisions has received less attention. This study identifies and highlights what is currently understood about the role of seat belt restraints and components in rear-end collisions from the existing literature in detail for the first time. Previous studies that have investigated the role of pretensioning in occupant motion and loading did not provide detailed assessments of pretensioning effects on webbing loads and displacement, nor did they discuss the relationship between pretensioner deployment and latch plate design.

Obesity rates are increasing among the general population. This study investigates the effect of obesity on ejection and injury risk in rollover crashes through analysis of field accident data contained in the National Automotive Sampling System-Crashworthiness Data System (NASS-CDS) database. The study involved front outboard occupants of age 15+ years in 1994+ model year vehicle rollover crashes. Occupants were sorted into two BMI groups, normal (18.5 kg/m2 ≤ BMI < 25.0 kg/m2) and obese (BMI ≥30 kg/m2). Complete and partial ejection risks were first assessed by seating location relative to roll direction and belt use. The risk of serious-to-fatal injuries (MAIS 3+F) in non-ejected occupants were then evaluated. The overall risk for complete ejection was 2.10% ± 0.43% when near-sided and 2.65% ± 0.63% when far-sided, with a similar risk for both the normal and obese BMI groups.

Many side-impact collisions occur at speeds much lower than tests conducted by the National Highway Traffic Safety Administration (NHTSA) and the Insurance Institute for Highway Safety (IIHS). In fact, nearly half of all occupants in side-impact collisions experience a change in velocity (delta-V) below 15 kph (9.3 mph). However, studies of occupant loading in collisions of low- to moderate-severity, representative of many real-world collisions, is limited. While prior research has measured occupant responses using both human volunteers and anthropometric test devices (ATDs), these tests have been conducted at relatively low speeds (<10 kph [<6.2 mph] delta-V). This study evaluated near- and far-side occupant response and loading during two side impacts with delta-V of 6.1 kph and 14.0 kph (3.8 mph and 8.7 mph).

Occupant kinematics during rollover motor vehicle collisions have been investigated over the past thirty years utilizing Anthropomorphic Test Devices (ATDs) in various test methodologies such as dolly rollover tests, CRIS testing, spin-fixture testing, and ramp-induced rollovers. Recent testing has utilized steer maneuver-induced furrow tripped rollovers to gain further understanding of vehicle kinematics, including the vehicle's pre-trip motion. The current study consisted of two rollover tests utilizing instrumented test vehicles and instrumented ATDs to investigate occupant kinematics and injury response throughout the entire rollover sequences, from pre-trip vehicle motion to the position of rest. The two steer maneuver-induced furrow tripped rollover tests utilized a mid-sized 4-door sedan and a full-sized crew-cab pickup truck. The pickup truck was equipped with seatbelt pretensioners and rollover-activated side curtain airbags (RSCAs).

It is well known from field accident studies and crash testing that seatbelts provide considerable benefit to occupants in rollover crashes; however, a small fraction of belted occupants still sustain serious and severe neck injuries. The mechanism of these neck injuries is generated by torso augmentation (diving), where the head becomes constrained while the torso continues to move toward the constrained head causing injurious compressive neck loading. This type of neck loading can occur in belted occupants when the head is in contact with, or in close proximity to, the roof interior when the inverted vehicle impacts the ground. Consequently, understanding the nature and extent of head excursion has long been an objective of researchers studying the behavior of occupants in rollovers.

Physical evidence on the seat belt restraint system is one source of data used by investigators to determine whether or not an occupant was wearing their seat belt during a crash. Evidence of occupant loading on seat belts generated during crash events has been thoroughly researched and is well documented in the literature. However, there is a paucity of data regarding the physical evidence produced when fractured glass is introduced into the restraint system during occupant loading events. The objective of this study is to characterize the physical evidence generated by glass-to-seat belt interaction during low-level impact loading, and compare this evidence with the types of seat belt marks that can be generated inadvertently by accident scene bystanders, emergency responders, and crash investigators. The presence of glass particles in and around the vehicle at the end of a crash event may contribute to the inadvertent generation of physical evidence.