Search Results

Many components used in the aerospace industry are complex-shaped, without symmetric axes and parallel surfaces. Fabricating and repairing these components often require fixturing system to support manufacturing processes such as drilling, surface finishing, inspections and assembly. Currently available fixturing systems can be divided into dedicated and flexible fixtures. Among these, the flexible fixtures are suitable for rapidly changing fabricating processes and handling several complex-shaped components using same fixturing system. Background research suggested that the pin type fixturing system is the predominant design used in such applications to fix complex-shaped components. In pin type fixturing systems, force is applied to a single point of contact. This increases the pressure applied to the work piece and possibility of damaging these components. Further, conventional pins use rigid designs, which cannot adapt to the shape of the work piece.

Modern aerospace industry is continuously seeking new technologies due to potential increase in demand for new aircrafts which are to be produced on a single production line while reducing model changeover time and improving quality of the assembly process. In mass volume production, this can be achieved by fixing a large number of similar components using special-purpose jigs and fixtures. This type of jigs and fixtures can be largely found in Aerospace industry. In low volume production, improvement of re-configurable fixturing systems becomes a favourable way to reduce the cost of production per unit. A re-configurable fixturing system consists of standard components that can be used to satisfy different fixturing requirements. These fixtures are reusable and this enhances their flexibility and reduces the time and cost of development. It also offers the benefit of eliminating the need for dedicated tooling, dedicated fixturing, associated storage and floor space.

Currently the wing box rib assembly process requires the manual location and temporary fixing of components within product specific jig or fixtures for drilling. After drilling and reaming, parts are separated, cleaned, deburred prior to adding sealant, reclaiming and final bolting, but this may significantly increase cost, manufacturing lead-time, reduces flexibility and cannot usually be economically modified for use on other aircraft types. Due to potential increase in demand for the next generation single isle aircraft, existing tooling solutions have to be improved and new technologies have to be developed. This paper describes the development and testing of flexible tooling to provide clamping and support for drilling wing box ribs to mating rib posts within a restricted environment. Results are presented along with a discussion of the problems that may be encountered during clamping trials.

The aerospace manufacturing sector is continuously seeking automation due to increased demand for the next generation single-isle aircraft. In order to reduce weight and fuel consumption aircraft manufacturers have increasingly started to use more composites as part of the structure. The manufacture and assembly of composites poses different constraints and challenges compared to the more traditional aircraft build consisting of metal components. In order to overcome these problems and to achieve the desired production rate existing manufacturing technologies have to be improved. New technologies and build concepts have to be developed in order to achieve the rate and ramp up of production and cost saving. This paper investigates how to achieve the rib hole key characteristic (KC) in a composite wing box assembly process. When the rib hole KC is out of tolerances, possibly, the KC can be achieved by imposing it by means of adjustable tooling and fixturing elements.

A modern aircraft wing contains many complex pipes and ducts which, amongst other functions, form the fuel management and bleed air systems. These parts are often fabricated from thin sheet material using a combination of forming and welding and the manufacturing process is predominantly manual requiring highly skilled labor. Since each wing may only contain one or two of each part type the product volumes are very low, typically a few hundred per year. This means that conventional mass production approaches used in, for example the automotive industry, are not economically viable and the parts are thus disproportionately expensive. The current fabrication process involves splitting the component into parts that can be press formed from sheet, laser trimmed and then manually welded together in a fixture. This process requires a perfect fit between the parts whose quality is reliant on the initial forming process.