Search Results

The use of early intake valve closing (EIVC) can lead to improvements in spark-ignition engine efficiency. One of the greatest barriers facing adoption of EIVC for high power-density applications is the challenge of boosting as EIVC strategies reduce volumetric efficiency. Turbochargers with variable nozzle turbines (VNT) have recently been developed for gasoline applications operating at high exhaust gas temperatures. The use of a single VNT as a boost device may provide a lower-cost option compared to two-stage boosting systems or 48 V electronic boost devices for some EIVC applications. A predictive model was created based on engine testing results from a 1.6 L turbocharged gasoline direct injection engine [1]. The model was tuned so that it predicted burn-rates and end-gas knock over an engine operating map with varying speeds, loads, compression ratios and fuel types.

The thermal efficiency benefits of low-pressure (LP) exhaust gas recirculation (EGR) in spark-ignition engine combustion are well known. One of the greatest barriers facing adoption of LP-EGR for high power-density applications is the challenge of boosting. Variable nozzle turbines (VNTs) have recently been developed for gasoline applications operating at high exhaust gas temperatures (EGTs). The use of a single VNT as a boost device may provide a lower-cost option compared to two-stage boosting systems or 48 V electronic boost devices for some LP-EGR applications. A predictive model was created based on engine testing results from a 1.6 L turbocharged gasoline direct injection (GDI) engine [1]. The model was tuned so that it predicted burn-rates and end-gas knock over an engine operating map with varying speeds, loads, EGR rates and fuel types.

This paper describes the simulation, design, and testing of a mechanically supercharged 2.4L I-4 gasoline direct injection engine with Miller cycle late intake valve closing and high geometric compression ratio. Engine downspeeding is also achieved through modified transmission gear ratios. A 3.3L naturally-aspirated V6 engine was chosen as the benchmark for comparison. Intended vehicle application is a mid-size passenger car or small/mid-size CUV. The CAE tool GT-Power was used for component selection and air path development. The powertrain simulation model was then exercised to show both improved fuel economy and performance compared to the V6 baseline engine. The design of a bespoke integrated supercharger with magnetic clutch, charge air cooler, and intake manifold was made and procured. A large new software aggregate was ported into an existing production ECU with modified internal circuitry.

In order to improve power density, the majority of diesel engines have intake manifold pressures above atmospheric conditions. This allows for the introduction of more fuel, which results in more power. Except for a few applications, these engines receive charged air from a turbocharger. The turbocharger develops boost by converting exhaust gas energy into power. This power is then used to compress the intake charge. The medium- and heavy-duty engine markets have both stringent regulatory targets and customer demand for improved fuel efficiency. Two approaches used to meet fuel efficiency targets are downspeeding and downsizing. Until now, the industry has adapted to the turbocharger lag experienced during a transient acceleration event. This performance deficiency is severely exaggerated when the displacement and speed of an engine are reduced. The solution proposed to improving fuel economy, while maintaining equivalent performance, is supercharging.

The problem with traditional drive cycle fuel economy analysis is that kinematic (backward looking) models do not account for transient differences in charge air handling systems. Therefore, dynamic (forward looking) 1D performance simulation models were created to predict drive cycle fuel economy which encompass all the transient elements of fully detailed engine and vehicle models. The transient-capable technology of primary interest was mechanical supercharging which has the benefit of improved boost response and "time to torque." The benefits of a supercharger clutch have also been evaluated. The current US class 6-8 commercial vehicle market exclusively uses turbocharged diesel engines. Three vehicles and baseline powertrains were selected based on a high-level review of vehicle sales and the used truck marketplace. Fuel economy over drive cycles was the principal output of the simulation work. All powertrains are based on EPA 2010 emission regulations.