Search Results

Recently, for protection of the environment, the regulation of automobile fuel consumption and exhaust gas emission has been strengthened. In light of such circumstances, automobile parts are generally required to be able to improve fuel efficiency and reduce exhaust gas emission. In order to meet such requirements, the structure of fuel/exhaust-related devices has become complicated. Redesigns of future products that will be increasingly complex will lengthen the development period and reduce cost efficiency seriously.

A new engine starter is developed for the purposes of downsizing and improving response time. A feed screw is used in the proposed starter, and its behavior is as follows. The motor shaft connected to the feed screw rotates, and the pinion gear with an internal screw then moves along its axis and stops at the end of the screw. The ring gear connected to the engine is located at the same axial position at which the pinion gear stops. Therefore, the pinion gear is engaged with the ring gear, and the engine is turned over. While a conventional starter requires a solenoid actuator to move the pinion gear, this device does not because the rotational movement of the screw is converted to the axial movement of the pinion gear. However, there is a problem whereby the rotational speed of the motor shaft decreases when the gear pair is engaged. This problem is resolved by adding a coil spring between the pinion gear and the end of the screw.

In order to increase the transfer efficiency in a metal V-belt type CVT (Continuously Variable Transmission), it is effective to lower belt clamping force from a current setting value. However, setting the clamping force too low will cause a macro slip (large belt slip). Thus, in order to set the clamping force to the proper level, the friction characteristics between the belt and the pulley (belt friction characteristics) must be understood in detail, and the macro slip threshold must be defined. In this paper, we shall propose a friction expression model for a metal V-belt type CVT and use this model to explain the speed reducing ratio dependence and speed dependence of the maximum friction coefficient (μmax). We shall also define the macro slip threshold in torque fluctuation environment.

This paper describes the development of a detection system of maximum force for a metal belt type CVT. By detecting the occurrence of a macro slip between a belt and pulleys in its early stage, the maximal point of the friction force can be detected while the belt is still running with sufficient clamping force. The ability of the detection system was examined using an experimental test rig of a continuously variable unit.