Search Results

Seat assessment is an important necessity for the growing auto industry. The design of seats is driven by customer’s demand of comfort and aesthetics of the vehicle interiors. Some of the few seat assessments are H-point prediction with H-point Machine (HPM); backset prediction with Head Restraint Measuring Device (HRMD); seat hardness and softness. Traditional seat development was through developing series of prototypes to meet requirements which involved higher costs and more time. The seat requirement of H-Point measurement is of focus in this paper. Though there are other commercial available software/methods to perform the H-point measurement simulations, the aim here was to assess the capabilities of an alternate Computer Aided Engineering (CAE) methodology using CAE tools - PRIMER and LS-Dyna. The pre-processing tools - Hypermesh and ANSA have been used for modeling and Hyperview tool used for reviewing the simulations.

Interest in pedestrian head injury has prompted a need to measure the potential of head injury resulting from vehicular impacts. A variety of head impactors have been developed to fulfill this measurement need. A protocol has been developed by the International Harmonization Research Activity (IHRA) to use head impactor measurements to predict head injury. However, the effect of certain characteristics of the various head impactors on the measurement procedure is not well understood. This includes the location of the accelerometers within the head-form and testing the head-form under the variety of conditions necessary to establish its global performance. To address this problem, a simple model of the IHRA head-form has been developed. This model was created using MADYMO© and consists of a solid sphere with a second sphere representing the vinyl covering. Stiffness and damping characteristics of the vinyl covering were determined analytically from drop test data of an IHRA head-form.

The International Harmonization Research Activities Pedestrian Safety Working Group (IHRA PSWG) has proposed design requirements for two head-forms for vehicle hood (bonnet) impact testing. This paper discusses the development of MADYMO models representing the IHRA adult and child head-forms, validation of the models against laboratory drop tests, and assessment of the effect of IHRA geometric and mass constraints on the model response by conducting a parameter sensitivity analysis. The models consist of a multibody rigid sphere covered with a finite element modeled vinyl skin. The most important part in developing the MADYMO head-form models was to experimentally determine the material properties of the energy-absorbing portion of the head-form (vinyl skin) and incorporate these properties into MADYMO using a suitable material model. Three material models (linear isotropic, viscoelastic, hyperelastic) were examined.