Search Results

The main aim of this work is to characterize the combustion phenomena and particulate matter in nano-size from the reactivity controlled compression ignition (RCCI) engine using neat hydrous ethanol as a low reactivity fuel. A four-cylinder diesel engine fueled with diesel (the volumetric blend of 95% petroleum diesel and 5% palm-based biodiesel) was operated on low and medium loads at 2,500 rpm without main diesel fuel injection modification and exhaust gas recirculation. Ethanol was injected at 1 bar pressure into the intake manifold while the w/w ratios of ethanol:diesel were varied between 0 and 0.77. An engine indicating system composed of an in-cylinder pressure transducer and a shaft encoder was used to investigate combustion characteristics using the first law of thermodynamics. A Scanning Mobility Particle Sizer and an Optical Particle Sizer were used to determine the particle number concentration and distribution over nano-size range.

Encouraging the use of alternative fuels available in Thailand is mainly due to fuel crisis within the past few decades. The government has recently drafted a renewable energy long-term plan to increase biofuel production. This has emboldened biodiesel to be used as fuel for agriculture and transportation, in particular. Diesel engines are promising for reducing carbon dioxide emissions related fuel energy consumption. Ordinarily, diesel combustion generates particulate matter and nitrogen oxides in trade-off relationship. However, advanced techniques for engine technology and aftertreatment devices have been abundantly developed to mitigate these hindrances. To break the trade-off emissions, an example technique is to fuel engines with biodiesel incorporated with exhaust gas recirculation. Among available options, nonthermal plasma (NTP) is one of the techniques that charges exhaust gas with high power electricity to reduce some emissions.

Increasing biodiesel content in mineral diesel is being promoted considerably for road transportation in Europe. With positive benefits in terms of net CO2 emissions, biofuels with compatible properties to those of conventional diesel are increasingly being used in combustion engines. In comparison to standard diesel fuel, the near zero sulphur content and low levels of aromatic compounds in biodiesel fuel can have a profound effect not only on combustion characteristics but on engine-out emissions as well. This paper presents analysis of particulate matter (PM) emissions from a turbo-charged, common rail direct injection (DI) V6 Jaguar engine operating with an RME (rapeseed methyl ester) biodiesel blended with ultra low sulphur diesel (ULSD) fuel (B30 - 30% of RME by volume). Three different engine load and speed conditions were selected for the test and no modifications were made to the engine hardware or engine management system (EMS) calibration.

Previous work of the authors' group has shown that biodiesel fuels as a replacement for conventional diesel fuel in engine combustion can reduce PM level dramatically while lowering some other regulated emissions as well. It has shown that these fuels have the potential to increase the overall engine performance due to their lower sulphur and/or aromatics content compared with standard diesel fuels. This paper presents a study on a single cylinder naturally aspirated direct injection (DI) diesel engine, equipped with a pump-line-nozzle injection system, operating with varied biodiesel fuel blends (0%, 25%, and 50% of RME by volume) with ultra low sulphur diesel fuel (ULSD). The detailed analysis of the measurement data shows that the ignition delay and exhaust emissions are affected by the proportion of biodiesel due to the effect of different physical and chemical properties of the two fuels.